N'Finity 3000 User Manual - page 10
Page 8
WE 081313
INSTALLING THE SYSTEM
Through-the-Wall
1. Slide the unit into the installation location from INSIDE the cellar,
make sure the controller side of the unit is inside of the cellar.
2. Slide the prepared single piece mounting bracket on the unit from
OUTSIDE the cellar.
3. On each side of the side of the unit you will notice 6 indents, these
mark 2 different installation depths. Select one of the 2 mounting
depths and attach the single piece mounting bracket to the unit with
the (6) supplied 1/2” self tapping screws. It is imperative to not use
self tapping screws longer than 1/2” in length.
4. Finally, secure the mounting bracket to the wall through the pre-drilled
holes with the (10) supplied #6 1 3/4" hex head screws. The screws should
penetrate the studs as well as the upper and lower supports to provide
adequate support for the unit.
5. Seal all cracks and gaps around the unit on the cellar side with an air-
tight sealant and caulking to prevent air leakage. The hole that the unit is
installed through is basically a break in the vapor barrier, an air tight seal
is imperative.
Note: If you use decorative moulding, it should be attached to the walls
and never to the cooling unit itself. The moulding itself should be remov-
able incase the unit needs servicing
Cellar Wall
3
4
Single Piece Mounting Bracket
The unit utilizes a single piece mounting bracket, this sturdy bracket frames the installation location
and secures the unit to the wall.
Applying Insulation Tape
Locate the (4) precut pieces of black foam tape included with the system, two larger pieces and two
smaller pieces. To apply, simply peel back the white-paper adhesive covering and place on the mount-
ing bracket. The large pieces are applied to the top and bottom while the smaller pieces are for the
sides. This foam creates a tight seal between the bracket and the wall.