1. DL manuals
  2. Nacecare
  3. Floor Machine
  4. Avenger AV 12QX
  5. Owner's Manual

Nacecare Avenger AV 12QX Owner's Manual

Other manuals for Avenger AV 12QX: Owner's Manual

Summary of Avenger AV 12QX

  • Page 1

    Owners manual for the av12qx prior to using this machine, make sure that you have read, and understand the safety and operating instructions for this machine. Nacecare solutions 1205 britannia road east mississauga, ontario, canada l4w 1c7 toll free: 1 800 387 3210 toll free fax: 1 800 709 2896.

  • Page 2

    2 safety instructions (read carefully) every electrical device must be used for its particular function only, respecting the manufacturer’s instructions. Failure to adhere to these instructions could result in serious bodily injury to the operator (shock, electrocution, etc.). Please read the follow...

  • Page 3

    3 setup this machine is designed to clean large areas of carpet. For normal operation, the machine drives forward, cleaning a path of 20 inches of carpet (see using as a self-propelled machine). It can also be used to clean small areas of carpet, with an additional hose and floor wand (see using wit...

  • Page 4

    4 using as a self-contained extractor 1. This machine is capable of being converted to a scrubber/dryer with an optional hard floor squeegee (p/n#18270e). 2. Lower the brush by turning the brush height adjustment knob counter clockwise. For carpet, the recommended setting is the second last notch. I...

  • Page 5

    5 control panel top view 4. Turn the vac motor, and brush motor switches to the “i” position. 5. Set the pump switch to the “i” position. In the “i” position, the pump will only work when the solution control lever is engaged. 6. On the lower left side of the machine, you can adjust the water flow b...

  • Page 6

    6 2. Connect the longer vacuum hose to the machine 3. Connect the longer solution hose to the machine 4. Switch on the vacuum motor by setting the switch to the "i" position. 5. Turn the pump to the "ii" position. In this position, the solution pump is always on. 6. To spray water you need to pull t...

  • Page 7

    7 after use, follow these steps 1. Empty solution tank. 2. Put some fresh water in the solution tank and pump this through the system. This will help keep the pump system clean. 1. Clean the recovery dome and gasket. 2. Thoroughly rinse and drain the recovery tank to prevent odors from developing. 3...