Nr1520 owners manual attention! Do not use the machine without having read the instructions carefully nacecare solutions 1205 britannia rd e. Mississauga, on, canada l4w 1c7 tel: 1 800 387 3210 fax: 1 800 709 2896 visit us on the web: www.Nacecare.Com.
Assembly instructions assembly of handle (nr1520) put the handle in vertical position, place its support on the four holes and insert all the four bolts (m8). Tighten the bolts one at the time, using a wrench to hold the lock nuts in place. Connect the shock to the support. Connect the handle cable ...
3 summary summary .........................................................................................................................3 upon delivery of the machine ....................................................................................4 technical data ................................
4 upon delivery of the machine when the machine is received, ensure to check that all components are in the box and that the machine has not been damaged in transport. This machine has been designed for use on hard floors. Any use of the machine, other than the recommended use is dangerous and could...
5 technical data unit nr1520 washing width inch 21.25” machine length inch 24” machine height (motor) inch 11.8” machine height (handle) inch 50” rounds per minute rpm 1500 voltage v 115 motor power w 1100 frequency hz 60 weight lbs 80 cable length ft 50 Ø wheels inch 4”.
6 machine preparation preparing the machine for first use upon delivery of the machine, please ensure that the owner’s manual is read thoroughly. If there is multiple users for the machine, ensure that they have a full understanding of how to use the machine in a safe manner. Abrasive pad driver ass...
7 machine preparation warning: use only high-speed pads. Using any other pads other than ones recommended for high speed could be dangerous and cause bodily harm or damage to the floor..
8 general safety rules any use of the machine other than the specified uses different from the instructions written here or recommended by nacecare solutions is prohibited and could cause bodily harm. Do not remove or replace the specification plates on the machine for any reason. Before operating t...
9 work preparation manoeuvre of the machine preparation:manoeuvering the machine by pulling the lever (a) lower the handle until the arms of the user are lightly bent. Using your thumb, push down on the safety lever (b) and then engage the motor with the two levers (c). The safety lever (a) must be ...
10 upon completion of work disassembly of brush/pad driver to remove the abrasive pad, lay the machine on the floor so it is resting on the handle. With the appropriate handle unscrew (counter clockwise rotation) the lock nut, remove the abrasive pad from the flange. Insert the lock nut after the pa...
11 trouble shooting guide the machine does not clean efficiently (it flutters or swings) if the machine has been stored in the upright position with the pad on it, the pad may have been deformed by the weight of the machine. Replace the pad/brush to correct this problem. The machine stops while work...
