Owners manual tp400f nacecare solutions 1205 britannia road east mississauga, ontario, canada l4w 1c7 toll free: 1 800 387 3210 toll free fax: 1 800 709 2896.
2 general information the tp400f is specially designed to clean upholstery, seats and any other fabric surface. This machine sprays specially formulated foam on the surface to be cleaned. This foam is created by mixing compressed air with water, and chemical. Normal carpet extraction methods penetra...
3 construction of the machine the tp400f is constructed with the following parts: • solution and recovery tanks • air compressor box • foam brush applicator and solution hose • vacuum hand tool and vacuum hose the machine is comprised of: • the air compressor and the compressed air tank, located in ...
4 2. Check that the valve at the foam outlet is closed. Connect the solution hose to the foam outlet and then open the foam outlet valve. 3. Raise the recovery tank, after releasing the spring clips holding it to the solution tank. 4. Add warm water into the solution tank. Add chemical in to the sol...
5 6. Connect the hose and the hand tool to the machine body. 7. Connect the plug of the machine to a properly grounded electrical socket. Switch the solution pump on by moving the switch to the position “i”. The pump switch is situated on the pump and vacuum motor control panel. 8. Switch the air co...
6 9. Switch on the vacuum motor. At this point the machine is ready for work. The optimal working air pressure is 4 bars. The air pressure is indicated on the air pressure gauge on the regulation panel. Working method 1. In order to spray foam, pull the lever on the foam brush accessory. Spray foam ...
7 machine maintenance it is highly recommended to follow these maintenance procedures: 1. After using the machine, before storing it, remove all the water from the 2 tanks. Put some clean water inside the solution tank and drain it completely by turning the pump on and spraying water through the foa...
8 control panel during testing in the factory, the machine is tuned for optimal performance. As applications and requirements may vary, the machine is provided with adjustment knobs. These adjustment knobs regulate the type of foam that is generated by the machine. There are 2 adjustments on the mac...
