® owner’s manual c 245bee four channel power amplifier en g li sh fr a n Ç a is es pa Ñ o l it a li a n o d eu ts ch n ed er la n d s sv en sk a РУ СС К И Й.
Save these instructions for later use. Follow all warnings and instructions marked on the audio equipment. 1 read instructions - all the safety and operating instructions should be read before the product is operated. 2 retain instructions - the safety and operating instructions should be retained f...
19 damage requiring service - unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a) when the power-supply cord or plug is damaged. B) if liquid has been spilled, or objects have fallen into the product. C) if the product has be...
Notes on environmental protection at the end of its useful life, this product must not be disposed of with regular household waste but must be returned to a collection point for the recycling of electrical and electronic equipment. The symbol on the product, user’s manual and packaging, point this o...
Quick start in case you simply cannot wait to experience the performance of your new nad c 245bee four channel amplifier, we provide the following quickstart instructions to get you underway. Please make all the connections to your c 245bee with the unit unplugged. It is also advisable to power-down...
1 standby button: press this button to switch on the c 245bee. The standby led indicator will turn from amber to blue. Pressing the standby button again turns the unit back to standby mode. Importantnotice therearpanelpowerswitchmustbeintheonpositionforthe standbybuttontoactivate. 2 standby led: thi...
1 channel b speakers (applicable to channel b only): connect the right speaker to the channel b speakers terminals marked “r +” and “r-” ensuring that the “r+” is connected to the “+” terminal on your loudspeaker and the “r-” is connected to the loudspeaker’s “-” terminal. Connect the terminals mark...
Identification of controls rear panel 6 channel a speakers (applicable to channel a only): connect the right speaker to the channel a speakers terminals marked “r +” and “r-” ensuring that the “r+” is connected to the “+” terminal on your loudspeaker and the “r-” is connected to the loudspeaker’s “-...
Automated turn-on logic (ato logic) the c 245bee may be turned on in any one of three discrete ways for complete system flexibility - from the front panel standby button, the 12v- trigger circuit or by the input signal-sensing circuit. The on/off power control is managed by the automated turn-on log...
Condition possible causes possible solutions nopower. The power cord is disconnected. • plug the power cord into the wall outlet securely. • c 245bee at standby mode. • press front panel standby button to switch on the c 245bee. • rear panel power switch not at on setting. • set the rear panel power...
Overall specifications channel a in or channel b in, channel a speakers or channel b speakers continuous output power into 8 Ω and 4 Ω (both channels driven) >35 w (ref. Rated thd, 20 hz – 20 khz) continuous output power into 8 Ω (mono, bridge mode) >70 w (ref. 20 hz - 20 khz, rated thd (250 mw to r...
Www.Nadelectronics.Com ©2009 nad electronics international a division of lenbrook industries limited all rights reserved. Nad and the nad logo are trademarks of nad electronics international, a division of lenbrook industries limited. No part of this publication may be reproduced, stored or transmit...