Summary of C 316BEE
Page 1
En g li sh fr anÇ ais esp aÑol it aliano deut sch nederl ands svensk a РУ ССКИЙ ® owner’s manual c 316bee stereo integrated amplifier.
Page 2
Save these instructions for later use. Follow all warnings and instructions marked on the audio equipment. 1 read instructions - all the safety and operating instructions should be read before the product is operated. 2 retain instructions - the safety and operating instructions should be retained f...
Page 3
19 damage requiring service - unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a) when the power-supply cord or plug is damaged. B) if liquid has been spilled, or objects have fallen into the product. C) if the product has be...
Page 4
Notes on environmental protection at the end of its useful life, this product must not be disposed of with regular household waste but must be returned to a collection point for the recycling of electrical and electronic equipment. The symbol on the product, user’s manual and packaging, point this o...
Page 5: Introduction
Introduction getting started unpacking and setup what’s in the box packed with your c 316bee you will find: • the amp 1 remote control with 3v cr2025 battery • this owner’s manual save the packaging please save the box and all of the packaging in which your c 316bee arrived. Should you move or other...
Page 6: Identification Of Controls
Identification of controls front panel 1 standby: with the rear panel power switch set to on position, press this button to switch on the c 316bee from standby mode. The standby led indicator will turn from amber to blue. Pressing the standby button again turns the unit back to standby mode. The c 3...
Page 7: Identification Of Controls
7 tone controls: the nad c 316bee is fitted with bass and treble tone controls to adjust the tonal balance of your system. The 12 o’clock position is “flat” with no boost or cut, and an indent indicates this position. Rotate the control clockwise to increase the amount of bass or treble. Rotate the ...
Page 8: Identification Of Controls
1 disc input: input for additional line level input signals such as cd, mini disc player or the output signal from a step-up amplifier for a turntable. Use a twin rca-to-rca lead to connect the auxiliary unit’s left and right “audio outputs” to this input. Note if an external media player is connect...
Page 9: Identification Of Controls
Using the amp 1 remote control the amp 1 remote control handset handles the key functions of the c 316bee. It has additional controls to remotely operate nad cd players. It will operate up to a distance of 23ft (7m). When a command from the remote control is received, the standby led indicator will ...
Page 10: Reference
Condition possible causes possible solutions no sound. • power ac lead unplugged or power not switched on. • check if ac lead is plugged in and power switched on. • mute on. • switch off mute. No sound one channel. • balance control not centered. • center balance control. • speaker not properly conn...
Page 11: Reference
Line level input input impedance (r and c) 50kΩ + 100pf input sensitivity (ref. Rated power) 200mv maximum input signal 7v line level output output impedance tape source z + 600Ω treble ±5db at 10khz bass ±8db at 100hz continuous output power into 8Ω 1 40w (16dbw) rated distortion 0.01% (ref. 20hz -...
Page 12
Www.Nadelectronics.Com ©2010 nad electronics international a division of lenbrook industries limited all rights reserved. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of nad electronics international c 316bee owner’s manual issue 1.4...