NAD C 558 Owner's Manual

Other manuals for C 558: Owner's Manual

Summary of C 558

  • Page 1

    English por tuguÊs fr anÇ ais esp aÑol it aliano deut sch nederl ands svensk a РУ ССКИЙ ® owner’s manual c 558 turntable.

  • Page 2

    Precautions read the operating instructions carefully and completely before operating the unit. Be sure to keep the operating instructions for future reference. All warnings and cautions in the operating instructions and on the unit should be strictly followed, as well as the safety suggestions belo...

  • Page 3

    What’s in the box packed with your c 558 you will find • switch mode power supply (smps) with interchangeable plugs • counterweight • audio cable connector (rca-to-rca lead) • single adaptor (for single lp’s) • allen keys 1,5mm and 2mm for possible setting of the tonearm • plastic tool (hook) for sp...

  • Page 4

    1 platter 2 felt mat 3 sub-platter 4 motor pulley 5 drive belt 6 plinth 7 on/off switch 8 dustcover 9 dustcover hinges 10 hinge fasteners 11 counterweight 12 tonearm 13 tonearm lift 14 tonearm rest and removable transport lock 15 anti-skating adjustment 16 headshell with finger lift 17 damped feet 1...

  • Page 5

    Setup platter, sub-platter, felt mat and drive belt installation 1 install sub-platter (3) and drive belt (5). 2 install the platter (1) on the sub-platter (3) and put the felt mat (2) on top of the platter. Adjusting the pulley height 1 adjust the pulley height if it taps against the platter. 2 car...

  • Page 6

    Setup vertical tracking angle setting (vta) 1 set the vertical tracking angle (vta) by putting a record on the platter. 2 when the needle is lowered into the record groove, the tube of the tonearm should be parallel to the surface of the record. If it is not, loosen both hexagonal screws in the tone...

  • Page 7

    Problem possible cause the platter doesn’t turn although the unit is switched on. • the unit is not connected to the mains power supply. • no mains power is being delivered at the socket. • the drive belt is not fitted properly or has slipped off. One or both channels have no output signal. • no sig...

  • Page 8

    General specifications turntable nominal speed 33/45 rpm, manual speed change (78 rpm possible with special pulley) speed variance 33rpm: wow and flutter 33rpm: signal to noise mechanical noise: - 40 db electrical noise: -68 db downforce range 0 - 30 mn 0 - 3.0 grams supplied counterweight system co...

  • Page 9

    9 english por tuguÊs fr anÇ ais esp aÑol it aliano deut sch nederl ands svensk a РУ ССКИЙ.

  • Page 10

    Www.Nadelectronics.Com ©2017 nad electronics international a division of lenbrook industries limited all rights reserved. Nad and the nad logo are trademarks of nad electronics international, a division of lenbrook industries limited. No part of this publication may be reproduced, stored or transmit...