? owner’s manual c 275bee stereo power amplifier english fr anÇ ais esp aÑol it aliano deut sch nederl ands svensk a РУ ССКИЙ.
Save these instructions for later use. Follow all warnings and instructions marked on the audio equipment. 1 read instructions - all the safety and operating instructions should be read before the product is operated. 2 retain instructions - the safety and operating instructions should be retained f...
19 damage requiring service - unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a) when the power-supply cord or plug is damaged. B) if liquid has been spilled, or objects have fallen into the product. C) if the product has be...
Notes on environmental protection at the end of its useful life, this product must not be disposed of with regular household waste but must be returned to a collection point for the recycling of electrical and electronic equipment. The symbol on the product, user’s manual and packaging, point this o...
Quick start in case you simply cannot wait to experience the performance of your new nad c 275bee stereo power amplifier, we provide the following quickstart instructions to get you underway. Please make all the connections to your c 275bee with the unit unplugged. It is also advisable to power-down...
1 standby button: press this button to switch on the c 275bee. The standby led indicator will turn from amber to blue. Pressing the standby button again turns the unit back to standby mode. Important notice the rear panel power switch must be in the on position for the standby button to activate. 2 ...
1 input select: slide this switch to either “fix” or “var”. When it is set to fix, the input signal is taken straight to the power amplifier’s circuitry. This setting is normally used in a system with only one power amplifier or multiple but identical power amplifiers. When the input select switch i...
Identification of controls rear panel 4 bridge mode: the c 275bee amplifier can be configured to be mono (bridge mode), more than doubling its output power. This way, the c 275bee can be used as part of a high power stereo or home- theatre system, by connecting additional power amplifiers. In bridge...
Automated turn-on logic (ato logic) the c 275bee may be turned on in any one of three discrete ways for complete system flexibility - from the front panel standby button, the 12v-trigger circuit or by the input signal-sensing circuit. The on/off power control is managed by the automated turn-on logi...
Condition possible causes possible solutions no power. • the power cord is disconnected. • plug the power cord into the wall outlet securely. • power switch set to off position. • set the power switch to on position. C 275bee always at standby mode; cannot be switched on using the front panel standb...
Overall specifications fixed in, speaker out continuous output power into 8 Ω and 4 Ω (both channels driven) >150 w (ref. Rated thd, 20 hz – 20 khz) continuous output power into 8 Ω (mono, bridge mode) >330 w (ref. 20 hz - 20 khz, rated thd (250 mw to rated power, ccif imd, dim 100) clipping power (...
Www.Nadelectronics.Com ©2013 nad electronics international a division of lenbrook industries limited all rights reserved. Nad and the nad logo are trademarks of nad electronics international, a division of lenbrook industries limited. No part of this publication may be reproduced, stored or transmit...
