- DL manuals
- NAD
- Amplifier
- C375BEE
- Owner's Manual
NAD C375BEE Owner's Manual
Summary of C375BEE
Page 1
En g li sh fr anÇ ais esp aÑol it aliano deut sch nederl ands svensk a РУ ССКИЙ ® owner’s manual c 375bee stereo integrated amplifier.
Page 2
Save these instructions for later use. Follow all warnings and instructions marked on the audio equipment. 1 read instructions - all the safety and operating instructions should be read before the product is operated. 2 retain instructions - the safety and operating instructions should be retained f...
Page 3
19 damage requiring service - unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a) when the power-supply cord or plug is damaged. B) if liquid has been spilled, or objects have fallen into the product. C) if the product has be...
Page 4
Important information for uk customers do not cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. If, nonet...
Page 5
Introduction getting started unpacking and setup what’s in the box packed with your c 375bee you will find: • the sr 8 remote control with 2 (two) aa batteries • this owner’s manual • a detachable ac power cord. Save the packaging please save the box and all of the packaging in which your c 375bee a...
Page 6
Identification of controls front panel 1 standby: with the rear panel power switch set to on position, press this button to switch on the c 375bee from standby mode. The standby led indicator will turn from amber to blue. Pressing the standby button again turns the unit back to standby mode. The c 3...
Page 7
9 input selectors: these buttons select the active input to the nad c 375bee and the signal sent to the loudspeakers, headphones and the pre out sockets. The buttons on the remote control handset duplicate these buttons. When selected, the corresponding input led indicator embedded around the bezel ...
Page 8
1 mp input: input for a media player or other line-level signal source. Use a twin rca-to-rca lead to connect the media player’s left and right “audio outputs” to this input. Note if an external media player is connected to the front mp socket (using a 3.5mm stereo plug) while listening to a mp line...
Page 9
8 pre out 1: the pre out 1 sockets can be used to drive an additional power amplifier. Use a twin rca-to-rca lead to connect to the left and right “audio input” of the power amplifier or processor to the pre out 1 sockets. Always turn the c 375bee and associated external power amplifiers off before ...
Page 10
14 ir in/out: these mini-jacks accept and output remote-controlled codes in electrical format, using industry-standard protocols, for use with “ir-repeater” and multi-room systems and related technologies. Ir in: this input is connected to the output of an ir (infrared) repeater (xantech or similar)...
Page 11
Using the sr 8 remote control the sr 8 remote control handset handles the key functions of the c 375bee as well as other nad stereo receivers, integrated amplifiers and preamplifiers. It has additional controls to remotely operate nad cd players, am/fm tuners and dedicated am/fm/dab tuners. It will ...
Page 12
8 vol [ ] : press [ ] button to increase or decrease the loudness level. Release the button when the desired level is reached. For nad receivers, the vfd will also show “volume up” or “volume down” while pressing sr 8’s [ vol ] . The volume buttons do not affect recordings made using the tape output...
Page 13
Condition possible causes possible solutions no sound. Power ac lead unplugged or power not switched on. • check if ac lead is plugged in and power switched on. • tape monitor selected. • de-select tape monitor mode. • mute on. • switch off mute. • rear pre-out/main-in amp links not fitted. • fit li...
Page 14
Preamplifier section line level input, pre out thd (2 vin 2 vout, ccif imd, dim 100) >0.004 % (ref. 20 hz – 20 khz) signal/noise ratio ihf >102 db (a-weighted, ref. 500 mv) >110 db (a-weighted, ref. 2v, volume maximum) >92 db (a-weighted, ref. 100 mv in 100 mv out - unity gain) channel separation - ...
Page 15
Overall specifications cd in, speaker out thd (250 mw to rated power, ccif imd, dim 100) signal/noise ratio >94 db (a-weighted, ref. 1 w) >113 db (a-weighted, ref. 150 w, volume set for 2v input) frequency response ± 0.2 db (ref. 20 hz - 20 khz, tone defeat on) 10 hz – 65 khz (ref. -3 db) channel se...
Page 16
Www.Nadelectronics.Com ©2008 nad electronics international a division of lenbrook industries limited all rights reserved. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of nad electronics international c 375bee owner’s manual issue 1-1...