English fr anÇ ais esp aÑol it aliano deut sch nederl ands svensk a РУ ССКИЙ © nad ci940 multi-channel amplifier ci 940 ® owner’s manual ci940 multi-channel amplifier.
Save these instructions for later use. Follow all warnings and instructions marked on the audio equipment. 1 read instructions - all the safety and operating instructions should be read before the product is operated. 2 retain instructions - the safety and operating instructions should be retained f...
19 damage requiring service - unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a) when the power-supply cord or plug is damaged. B) if liquid has been spilled, or objects have fallen into the product. C) if the product has be...
Notes on environmental protection at the end of its useful life, this product must not be disposed of with regular household waste but must be returned to a collection point for the recycling of electrical and electronic equipment. The symbol on the product, user’s manual and packaging, point this o...
Introduction getting started quick start refer to the supplied ci 940 quick setup guide for basic instructions in setting up your new nad ci 940. The following important notes must also be observed when setting up your ci 940. Important setup notes · before setting up or making connections, ensure t...
1 standby button · press this button to switch on the ci 940. The standby led indicator will turn from amber to blue. · pressing the standby button again turns the unit back to standby mode. Important notice the rear panel power switch must be in the on position for the standby button to activate. 2...
1 zone 2 (input/output) · these input/output terminals are dedicated only for zone 2 speakers and corresponding stereo and bridge mode settings. · always turn off the ci 940 and other components in the system before connecting or disconnecting anything to the input/output terminals. · connect the ou...
7 +12v trigger in/input sense - off/auto · this dual function switch alternates between sensing a +12v input as applied through the +12v trigger in jack or sensing any active input signal applied at zone 1 input or zone 2 input terminals. · at auto setting and with the +12v trigger input of the ci 9...
Automated turn-on logic (ato logic) the ci 940 may be turned on in three discrete ways for complete system flexibility - from the front panel standby button, the 12v-trigger circuit or by the input signal-sensing circuit. The on/off power control is managed by the automated turn-on logic or ato logi...
Condition possible causes possible solutions no power. • the power cord is disconnected. • plug the power cord into the wall outlet securely. • ci 940 at standby mode. • press the front panel standby button to switch on the ci 940. (+12v trigger in/input sense switch set to off position) • rear pane...
Overall specifications continuous output power into 8 ohms and 4 ohms (both channels driven) >35 w (ref. Rated thd, 20 hz – 20 khz) continuous output power into 8 ohms (mono, bridge mode) >70 w (ref. 20 hz - 20 khz, rated thd (250 mw to rated power, ccif imd, dim 100) ihf dynamic power 55 w (8 ohms)...
Www.Nadelectronics.Com ©2015 nad electronics international a division of lenbrook industries limited all rights reserved. Nad and the nad logo are trademarks of nad electronics international, a division of lenbrook industries limited. No part of this publication may be reproduced, stored or transmit...
