M25 seven channel power amplifier english franÇais deutsch nederlands esp aÑol it aliano por tuguÊs svenska owner’s manual ® m25 07092005.Qxd 1/4/2006 6:54 pm page 1.
2 important safety instructions important safety instructions • save these instructions for later use. • follow all warnings and instructions marked on the audio equipment. 1 read instructions - all the safety and operating instructions should be read before the product is operated. 2 retain instruc...
3 important safety instructions 19 damage requiring service - unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a) when the power-supply cord or plug is damaged. B) if liquid has been spilled, or objects have fallen into the p...
4 panel connections/controls front panel controls m25 07092005.Qxd 1/4/2006 6:55 pm page 4.
3 spade wire pin figure 2 figure 1 m25 07092005.Qxd 1/4/2006 6:55 pm page 5.
6 english franÇais deutsch esp aÑol it aliano por tuguÊs svenska about the m25 designed specifically for home theatre and custom installation set-ups, the nad m25 power amplifier delivers uncompromising performance. It combines supreme reliability, flexibility, and performance with outstanding value...
7 english franÇais deutsch esp aÑol it aliano por tuguÊs svenska installation precautions warning - to reduce the risk of fire or electrical shock, do not expose the amplifier to rain or moisture. Caution - for units factory-set at 115 volts ac match the wide blade of the power plug to the wide slot...
3. Input level controls the amplifier is equipped with separate input level controls for each channel. Before turning on the m25 for the first time, make sure all level controls are in their normal full-clockwise position. With the input levels set to the maximum position, the gain is exactly confor...
Front panel controls 1. Power switch/standby led press this button to switch the amplifier on or off. The power led located just above the power button and protection leds (see protection led below) will light up. After a few seconds, the protection leds will switch from red to blue, indicating that...
10 english franÇais deutsch esp aÑol it aliano por tuguÊs svenska problem no sound no sound on one channel no sound on surround channels no sound on center channel weak bass/ diffuse stereo image cause • power ac lead unplugged or power not switched on • speaker not properly connected or damaged. • ...
Www.Nadelectronics.Com ©2006 nad electronics international a division of lenbrook industries limited all rights reserved. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of nad electronics international m25 manual 01/06 printed in china...
