NAD M51 Owner's Manual

Other manuals for M51: Owner's Manual, Quick Start Manual
Manual is about: Direct Digital DAC

Summary of M51

  • Page 1

    English fr anÇ ais esp aÑol it aliano deut sch nederl ands svensk a РУ ССКИЙ ® owner’s manual m51 direct digital dac.

  • Page 2

    Save these instructions for later use. Follow all warnings and instructions marked on the audio equipment. 1 read instructions - all the safety and operating instructions should be read before the product is operated. 2 retain instructions - the safety and operating instructions should be retained f...

  • Page 3

    19 damage requiring service - unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a) when the power supply cord or plug is damaged. B) if liquid has been spilled, or objects have fallen into the product. C) if the product has be...

  • Page 4

    Notes on environmental protection at the end of its useful life, this product must not be disposed of with regular household waste but must be returned to a collection point for the recycling of electrical and electronic equipment. The symbol on the product, user’s manual and packaging, point this o...

  • Page 5

    Introduction getting started thank you for choosing nad. M51 direct digital dac is another excellent product that exemplifies nad’s unique direct digital technology. The m51 uses a very powerful processing engine that operates at much higher speed and with much greater accuracy than typical d-to-a c...

  • Page 6

    1 standby button • press this button to switch on the m51 from standby mode. The standby led indicator will turn from amber to blue and illuminate the vfd. • pressing the standby button again turns the unit back to standby mode. Note in order to turn on the m51 from standby mode or back to standby m...

  • Page 7

    1 unbalanced • use a twin rca-to-rca lead to connect these sockets to the left and right analog input of a receiver or amplifier. 2 balanced • connect these xlr connectors to the corresponding xlr input of professional audio amplifiers. • ensure that proper pin configurations are followed – pin 1: g...

  • Page 8

    10 ir in • this input is connected to the output of an ir (infrared) repeater (xantech or similar) or the ir output of another component to allow control of the m51 from a remote location. 11 power • supply the ac mains power to the m51. • when the power switch is set to on position, the m51 goes to...

  • Page 9

    1 on: switch on m51 from standby mode. Off: switch m51 to standby mode. 2 aes/ebu, hdmi 1, coax, usb, hdmi 2, opt: select source input. 3 setup: bring up volume setup menu. Polar.: bring up polarity settings menu. 4 dim: reduce or restore vfd brightness (5 levels of brightness). Display: use in rena...

  • Page 10

    Nad usb audio in order to stream your computer audio via m51, ensure that the sound or audio device setting of your computer is set to “nad audio 2.0 output”. A nad usb audio driver can be downloaded via the nad website link http://nadelectronics.Com/products/masters-series/m51-direct- digital-dac. ...

  • Page 11

    Condition possible causes possible solutions no usb audio. • nad usb audio is not installed in your pc. • download nad usb audio driver from nad website and install to your pc. • sound or audio device setting of your pc or mac is not set to “nad audio 2.0 output”. • set your pc or mac audio or sound...

  • Page 12

    Overall specifications rated distortion (thd+n with aes 17 filter) im distortion signal-to-noise ratio channel separation > -115 db (ref. 0 dbfs volume -1db) sample rate 32 khz to 192 khz (usb and digital s/pdif) frequency response ±0.5 db (ref. 20 hz – 96 khz @ 192 khz sample rate) output level 2v ...

  • Page 13

    13 english fr anÇ ais esp aÑol it aliano deut sch nederl ands svensk a РУ ССКИЙ.

  • Page 14

    Www.Nadelectronics.Com ©2012 nad electronics international a division of lenbrook industries limited all rights reserved. Nad and the nad logo are trademarks of nad electronics international, a division of lenbrook industries limited. No part of this publication may be reproduced, stored or transmit...