Summary of T741
Page 1
T741 av surround sound receiver owner’s manual gb t741 manual (gb) 22/10/01 3:56 pm page 1.
Page 2
Gb 2 t741 manual (gb) 22/10/01 3:56 pm page 2.
Page 3
Gb 3 notes on installation. Your nad t741 should be placed on a firm, level surface. Avoid placing the unit in direct sunlight or near sources of heat and damp. Allow adequate ventilation. Do not place the unit on a soft surface like a carpet. Do not place it in an enclosed position such a bookcase ...
Page 4
Gb 4 explanation of graphical symbols the lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock ...
Page 5
Gb 5 electric power 1 power sources - connect this unit only to power sources specified in the operating instructions, and as marked on the unit. 2 polarization - as a safety feature, some units are equipped with polarized ac power plugs which can only be inserted one way into a power outlet. If it ...
Page 6
Gb 6 fig. 1 rear panel connections fig. 2 front panel controls 2 6 7 9 8 11 3 4 10 12 5 +12v trigger out 4 8 7 9 10 11 12 13 14 15 16 17 18 3 t741 manual (gb) 22/10/01 3:56 pm page 6.
Page 7
Gb 7 fig. 3 remote control 1 2 6 8 11 22 25 10 13 23 26 4 14-18 20 3 5 7 9 12 19 21 24 fig. 4 fig. 5 fig. 6 t741 manual (gb) 22/10/01 3:56 pm page 7.
Page 8
Gb 8 rear panel controls (figure 1) 1. Fm & am antenna am antenna - an am loop antenna is supplied with the t741 and is required for am reception. Open the clip terminal lever and insert the wire from the antenna. Closing the lever will lock the wire in place (fig. 5). Test various positions for the...
Page 9
Gb 9 6. Audio pre-outs / subwoofer out audio pre-outs - the nad t741 receiver has five power amplifiers built-in to power all the speakers connected to it (left, right, center, left surround, right surround). It is also possible to use the t741 as a pre- amplifier to drive external power amplifiers....
Page 10
Gb 10 10. Nad-link in out the nad-link connector is used to pass commands from other units fitted with nad-link connectors. This allows centralized control of a complete system, and also allows some of the basic functions of other nad components (such as a cd player) also equipped with nad-link to b...
Page 11
Gb 11 4. Fm/am the fm/am button switches the tuner section from the am band to the fm band and vice-versa. The display panel shows the frequency of the tuned station and which band is selected. The fm tuning is in 0.05 mhz increments, am tuning is in 9 khz or 10khz increments, depending on the versi...
Page 12
Gb 12 the control is also used to adjust various set-up settings and levels for the t741. In conjunction with the setup button (no. 17) the speakers size and delay can be adjusted; in conjunction with the tone control button (no. 18) the bass and treble levels can be adjusted. Refer also to sections...
Page 13
Gb 13 16. Surround mode with the surround mode buttons the available surround sound modes can be selected. The selected surround mode is permanently indicated in the display area. The surround mode buttons scroll through the available surround sound modes: with any of the digital inputs 1, 2 & 3 (pr...
Page 14
Gb 14 storing and recalling presets to store a preset • tune to the radio station you wish to enter into a preset (refer to chapter “front panel controls”; section 8). If the station is transmitting rds information, the rds indicator will light up and station initials will be shown in the display pa...
Page 15
Gb 15 4. Numeric keypad rcvr mode - the numeric keypad can be used to directly access fm and am station presets by pressing the number of the desired preset. Dvd mode - these keys can also be used to select cd tracks and enter chapter numbers in the dvd mode (consult the dvd players instruction manu...
Page 16
Gb 16 13. Tune mode / return the tune mode button functions the same as the button of the front panel of the t741, switching between the tune mode and the preset mode. See complete description in the front panel controls section above. In dvd mode this button’s function is determined by the individu...
Page 17
Gb 17 now rotate the volume/setup knob until rear lar (current setting for the surround speakers) appears in the display window. Press the set up button again to change the size. Each press of the set up button will change the setting for that speaker: rear (surround speakers) can be set to lar, sma...
Page 18
Gb 18 tips for setting delay measure the distance from the listening position to the center speaker (dc) and to one of the front speakers (dfl or dfr). Subtract the center channel distance from the front l or r channel distance. For example, if the front speakers are 12 feet (3.7 m) from the listeni...
Page 19
Gb 19 problem no sound no sound on one channel no sound on surround channels no sound on center channel “dolby digital” or “dts” auto-detection function does not work weak bass/ diffuse stereo image remote control handset not working no sound with tuner noise, hiss on am and fm distortion on fm whis...
Page 20
Www.Nadelectronics.Com ©2001 nad electronics international all rights reserved. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of nad electronics international t741 manual 10/01 printed in malaysia t741 manual (gb) 22/10/01 3:56 pm pag...