WHAT’S IN THE BOX
Packed with your VISO FIVE you will find
• An AM loop antenna.
• A FM ribbon-wire antenna with balun.
• A removable AC cable (if you wish, any IEC-standard AC cable of suitable
wattage may be substituted).
• The HTR 7 remote control with 4 (four) AAA batteries.
• This owner’s manual.
SAVE THE PACKAGING
Please save the box and all of the packaging in which your VISO FIVE
arrived. Should you move or otherwise need to transport your VISO FIVE,
this is by far the safest container in which to do so. We’ve seen too many
otherwise perfect components damaged in transit for lack of a proper
shipping carton, so please: Save that box!
CHOOSING A LOCATION
Choose a location that is well ventilated (with at least several inches to
both sides and behind), and that will provide a clear line of sight, within
23 feet/7 meters, between the VISO FIVE’s front panel and your primary
listening/viewing position—this will ensure reliable infrared remote control
communications. The VISO FIVE generates a modest amount of heat, but
nothing that should trouble adjacent components.
It is especially important that sufficient ventilation be provided. If you are
contemplating on locating the VISO FIVE within a cabinet or other furniture,
consult your NAD audio/video specialist for advice on providing adequate
airflow.
QUICK START
In case you simply cannot wait to experience the performance of your
new NAD VISO FIVE, we provide the following “Quick Start” instructions to
get you underway. Before the steps below, connect your VISO FIVE to a
TV/monitor.
Please make all the connections to your VISO FIVE with the unit unplugged.
It is also advisable to power-down or unplug all associated components
while making or breaking any signal or AC power connections.
PLAY A CD OR DVD MOVIE
• Connect the VISO FIVE’s composite Video or S-Video “MONITOR OUT”
jack to your TV/monitor’s corresponding input.
• Connect your speakers to the VISO FIVE’s FRONT R, FRONT L, SURROUND
R, SURROUND L and CENTER terminals. Make sure to connect red
to red (“+”) and black to black (“-”) with care to avoid stray wires or
strands crossing between terminals. If your system includes a powered
subwoofer, connect the VISO FIVE’s “SUBWOOFER PRE-OUT” jack to its
line input.
• Connect the AC cord to the AC inlet and then plug into an AC outlet;
the LED indicator around the POWER button will be illuminated amber
indicating the VISO FIVE is in standby mode ready to accept commands
from either the front panel power switch or the HTR 7 remote.
• Press “DVD” at the HTR 7 remote’s Device Selector section and then
“OPEN/CLOSE” button.
• Insert the media and press [ PLAY] button to start playback. You
should hear sound from VISO FIVE, and see an image on the TV/monitor.
(If one or the other fails to appear, check your TV/monitor’s input
settings or VISO FIVE’s audio/video connections).
Enjoy the movie or music, but be sure to set aside time to read this manual
thoroughly, and to set up, calibrate, and configure your VISO FIVE carefully
and completely.
INTRODUCTION
GETTING STARTED
7
ENGLISH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
Р
У
С
СКИЙ