Xa series amplifiers stereo power amplifiers owner’s manual.
Xa series 3 s t e r e o p o w e r a m p l i f i e r date of purchase ____________________________________ dealer’s name ______________________________________ city _______________________________________________ state _____________________ zip _____________________ model # __________________________...
Important safety instructions warning attention : risque de choc electrique ne pas ouvrir an equilateral triangle enclosing a lightening flash/arrowhead symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure which may be of sufficient m...
Front & rear connections 5 front panel 1 6 2 3 4 5 1. Power switch to turn the unit on or off, press the upper or lower portion of this button. Before turning on the amplifier, check all connections and turn down the level controls. A momentary muting is normal when turning the amplifier on or off. ...
Front & rear connections 6 installation to ensure years of enjoyment from your nady audio xa-900/1100, please read and understand this manual thoroughly before using the unit. Inspection your xa -900/1100 was carefully packed at the factory in packag- ing designed to protect the units in shipment. B...
Connections • stereo (two-channel) mode to put the amplifier into stereo mode, first turn the amplifier off, then slide the mode selector switch (13) to the bottom “stereo” position, and properly connect the input/output wiring as shown. (note: do not connect a speaker load less than 2 ohms as it ca...
Connections 8 • parallel (mono) mode to put the amplifier in parallel-mono mode, first turn the amplifier off, then slide the mode selector switch (13) to the middle “parallel (mono)” position and properly connect the input wiring as shown. A signal into any input jack will drive both channels direc...
Block diagram 9.
Specifications 10 power specifications xa-900 xa-1100 2 Ω 400 + 400 730 + 730 4 Ω 300 + 300 475 + 475 8 Ω 200 + 200 300 + 300 bridged 4 Ω 675 1100 electrical specifications xa-900 xa-1100 input sensitivity 1.15v (+3.4dbu) 1.15v (+4dbu) input impendance 10k Ω unbalanced & balanced frequency response ...
Service for your nady audio product (u.S.) should your nady audio product require service, please contact the nady service department via telephone at (510) 652-2411, or e-mail at service@nady.Com. (international) for service, please contact the nady audio distributor in your country through the dea...
