Nady Systems 2W-1KU Owner's Manual - page 13
13
setting increases battery life and also
optimizes the number of channels that can
be used simultaneously in a given location.
Use this setting for normal use not requiring
maximum operating range. A range walk
test before use will determine which setting
is best for your application.
Slide the On/Off switch to the “ON”
position and the microphone is now ready to
use. The receiver’s RF Signal Meter (12) and
one Diversity a or B (8/13) indicator should
now be on, indicating a received signal from
the transmitter. Adjust the volume of the
receiver per Connecting the Audio Output
section above.
note: Avoid acoustic feedback (howling or
screeching) by taking care in selecting PA volume,
transmitter location and speaker placement.
The RF Signal meter and the Diversity A or B
indicator on the receiver’s LCD display should
be “ON” in normal operation.
BT-1KU Bodypack Transmitter
(lT, lT/HM or GT)
Buttons Function
The RF Power level Switch (45) is used to
select Hi/Low power transmission.
When the Set Button (44) is pressed, the LCD
main menu will cycle in the following order:
MAIN MENU
>
VOLUME
>
GROUP
>
CHANNEL
>
MAIN MENU
(repeats)
The
(Up) or (Down) Buttons (43) work in
the set mode only. They can be used to
change any Group/Channel as selected
(if not using IR Sync from receiver). They
can also be used to select the desired Input
audio level VOL setting. Or they can be
used to turn on the LCD display.
During manual programming, the selected
function will flash for five seconds or press
the Set button to confirm the selection and
the display will return to the main menu.
Setting up the Transmitter
The BT-1KU bodypack requires two AA size
batteries to operate. To install the batteries
into the battery compartment, lift the
Battery Compartment Door (48) by grabbing
the two spring-loaded locking tabs and pull
out, exposing the Battery Compartment (47).
Insert two fresh aa batteries (50) according
to the correct polarity as indicated on the
transmitter body. Close the battery cover,
ensuring the cover is snapped shut. Fresh
alkaline batteries can last provide up to 8-10
hours of operation, but in order to ensure
optimum performance it is recommended
that the batteries be replaced after 6-8 hours
of use or as indicated necessary by the
flashing Battery Meter “BaTT” Icon (30).
Connecting Input audio Source
Use the audio Input (40) 3.5mm locking mini
jack for connecting the audio input cord
from lapel mic (LT), Headmic
™
(LT/HM),
or instrument (GT), depending on which
version transmitter is being used. Secure
the connection to the cable by lining up
the slot of the 3.5mm mini connector and
turning the ring to securely lock in.
Powering the Transmitter On/Off
To turn on the transmitter, slide the
Power Off/Mute/On Switch (41) to the “MUTE”
(middle) position (transmitter on, audio
muted). The LCD backlight will light up.
The unit is now on. After ten seconds the
backlight will automatically turn off. The
Group (27), Channel (28), Input Volume level (29)
and Battery Meter (30) remain on in normal
operation.
As many of the five LCD battery levels
should stay lit as possible, indicating usable
battery strength. As the batteries weaken,
fewer of the level indicators stay lit until
only one bar shows, which will then flash to
warn that the batteries are now too low and