Nady Systems DKW-3 HT Owner's Manual - page 4

4

Handheld Microphone Transmitter

1. Unscrew the BaTTerY COMParTMenT 

COVer (8) and remove. Insert a fresh 

9V BaTTerY (9), observing correct polarity 

as marked, and screw the cover back on 

to the microphone. To ensure proper battery 

contact, the cover must be screwed on 

completely.

2. Turn on the handheld mic by sliding the 

OFF/On swITCH (10) to the “On” position. 

The BaTTerY InDICaTOr leD (11) will give a 

single quick flash, indicating usable battery 

strength. In the case of a dead or low 

battery, the LED will either not go on at all or 

will stay on continuously, indicating that the 

battery should be replaced with a fresh one.

3. The microphone is now ready to use. 

The corresponding rX leD (7) on the DKW-3 

receiver should now be lit, indicating 

a received signal from the transmitter. 

Adjust the VOluMe (6) control of the 

receiver channels you are using clockwise 

to about 

3

/

4

 rotation, until the volume level 

is comfortable for your application.

Note: Observe care in selecting P.A. volume, 

transmitter location and speaker placement so 

that acoustic feedback (howling or screeching) 

will be avoided.

11

10

9

8