Dual receiver vhf wireless microphone system nady wireless systems are type accepted under fcc rules parts 90, 74 and 15. The device complies with rss-210 of industry & science canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) th...
Contents 2 contents ...........................................................................................2 introduction ....................................................................................3 using this manual .........................................................................
Thank you for purchasing a nady encore duet dual receiver wireless microphone system and congratulations on your choice. The encore duet is loaded with top professional operating features and is the best performance and price value available in vhf dual receiver wireless systems. Introduction this b...
Specifications 17 encore duet overall system performance frequency response 25-20,000 hz, +/-3db dynamic range 120db total harmonic distortion rf carrier frequency range 2 channels between 169-216 mhz frequency stability +/- 0.005%, crystal controlled modulation fm (f3e), +/-20khz max. Operating ran...
Encore duet receiver 5 1. Rackmounting the receiver there are 2 options available for rackmounting the encore duet receiver: singly or side-by-side with another encore series receiver. A. Single mounting: remove the receiver side mount clip (1) from each side of the receiver (as shown) and slide in ...
15 4. Microphone operation a. Turn on the link 2 by sliding the on/standby/off switch (41) to the standby position (transmitter on, audio muted) or the on position (transmitter and audio both on). The low battery indicator led (40) will give a single quick flash, indicating usable battery strength. I...
7 7 8 16 4 13 11 6 15 14 9 1 9 12 10 1 12 16 5 5 4 6 2 2 14 the link 2™ plug-in transmitter 14 1. Transmitter set-up first, slide open the battery compartment door (43) to expose compartment. Insert a fresh 9v alkaline battery (45), observing polarity. Close the battery compartment door. 2. Handheld...
13 1. Unscrew the battery compartment cover (17) and remove, exposing the battery holder (18). Insert a fresh 9v alkaline battery (19), observing the correct polarity as marked, and screw the cover back on to the microphone. Make sure the cover is screwed on completely. A fresh alkaline battery can ...
9 wgt instrument bodypack transmitter 12 1. Snap open the battery compartment (30) and insert a fresh 9v battery (31), observing the correct polarity. Close the compartment. The wgt is provided with a 3.5 mm locking jack (32) for connecting the instrument cable (35). To secure the connection, turn t...
1. Snap open the battery compartment (22) and insert a fresh 9v battery (23), observing the correct polarity. Close the compartment. 2. The wlt is provided with a 3.5 mm locking jack (24) for connecting the microphone. Plug in either the lavalier/lapel (25) or the headworn micro- phone (26), as supp...
