Nady wireless systems are type accepted under fcc rules parts 90, 74 and 15. The device complies with rss-210 of industry & science canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference receiv...
Contents 2 contents ...........................................................................................2 introduction .................................................................................... 3 using this manual.........................................................................
• available on selected frequencies in the vhf high band (171-216 mhz) for interference-free, long-range performance • proprietary companding circuitry for an industry-best 120db dynamic range, and the clearest, most natural sound available • operating range: up to 250 feet typical (depending on sit...
6 5. Connecting the audio output the encore i receiver provides both a fixed mic level balanced audio output xlr (14) and an adjustable line level unbalanced audio output 1/4" jack (13). The level from the unbalanced output is controlled by the rear panel volume control (6) . (note: as when making a...
1. Unscrew the battery compartment cover (17) and remove, exposing the battery holder (18) . Insert a fresh 9v alkaline battery (19), observing the correct polarity as marked, and screw the cover back on to the microphone. Make sure the cover is screwed on completely. A fresh alkaline battery can la...
1. Snap open the battery compartment (22) and insert a fresh 9v battery (23), observing the correct polarity. Close the compartment. 2. The wlt-15 is provided with a 3.5 mm locking jack (24) for connecting the microphone. Plug in either the lavalier/lapel (25) or the headworn micro- phone (26) , as ...
Wgt-15 instrument bodypack transmitter 12 1. Snap open the battery compartment (30) and insert a fresh 9v battery (31), observing the correct polarity. Close the compartment. The wgt-15 is provided with a 3.5 mm locking jack (32) for connecting the instrument cable (35). To secure the connection, tu...
The link 2™ plug-in transmitter 14 1. Transmitter set-up first, slide open the battery compartment door (43) to expose compartment. Insert a fresh 9v alkaline battery (45), observing polarity. Close the battery compartment door. 2. Handheld microphone installation • step 1 - rotate the transmitter's...
38 xlr connector – connects microphone to the transmitter module for signal input locking ring – locks microphone to the transmitter optional pouch – for lavalier bodypack operation (with beltclip and strap ring for securing) gain control switch – adjusts the input sensitivity (lo or hi) low battery...
(u.S.) should your nady encore i wireless microphone system require service, please contact the nady service department via telephone at (510) 652-2411 or e- mail to service@nadywireless.Com for a return authorization (r/a) number and a service quote (if out of warranty). Make sure the r/a number is...
Nady wireless systems are type accepted under fcc rules parts 90, 74 and 15. The device complies with rss-210 of industry & science canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference receiv...
