Nady Systems HT-6SC Owner's Manual

Summary of HT-6SC

  • Page 1

    Irw-2pa o w n e r s m a n u a l infrared wireless microphone pa system nady systems, inc. 6701 shellmound street • emeryville, ca 94608 usa tel: 510/652-2411 • fax: 510/652-5075 www.Nady.Com important safety instructions warning an equilateral triangle enclosing a lightning flash/arrowhead symbol is...

  • Page 2

    Contents .......................................................................................................2 introduction ...............................................................................................3 using this manual .............................................................

  • Page 3

    14 3 introduction thank you for purchasing the nady irw-2pa infrared wireless pa system and con- gratulations on your choice. The irw-2pa is loaded with top professional operating features and is the best performance and price value available in infrared wireless pa systems. This booklet gives instr...

  • Page 4

    4 13 system features irw-2pa infrared pa system • all-in-one infrared wireless pa system—ideal for schools, lectures, conferences, or karaoke applications • multi-functional wall hanging lockbox houses dual infrared wireless receiver, preamp, power amp, and transmitters with battery-charging holders...

  • Page 5

    12 5 installation 1. The irw-2pa lockbox should be positioned in the room while considering the following criteria: • ir sensors should be placed on either side of operating area and as close to microphone operating area as possible. All rules of sensor installation should be observed as per instruc...

  • Page 6

    (1) battery compartment/cover (2) power switch (3) power led indicator (2) (1) (3) 1. Transmitter set-up unscrew and remove the battery compartment cover (1) by sliding it down off the microphone to expose the battery holders. Insert 2 fresh aa alkaline batteries, nimh rechargeable batteries, or the...

  • Page 7

    10 7 3. Connections: a. Connect the irw-1s ir sensors to the irw-2pa receiver by plugging the sensor coaxial extension cable plugs into the infrared sensor inputs (1). Each sensor input will receive both channels a and b signals. To increase mobility and maximum range, additional sensors can be adde...

  • Page 8

    9 8 irw-2pa wireless receiver pa 1. Powering the irw-2pa turn on the irw-2pa using the power switch (17) located inside the lockbox on the lower right panel. When powered on, the ch a and ch b ir reception led in- dicators (6) will light green if the corresponding transmitters are on and red when th...