Nady Systems IRW-220X HT/LT/O - Nady Ir Wireless System Owner's Manual - page 4
9
SYSTEM FEATURES
4
IRW-220X DUAL-IR WIRELESS MICROPHONE RECEIVER
• Dual receiver allows 2 channel simultaneous operation of 2 transmitters (Ch A, Ch B)
• IR signal reception LED indicators
• Channel A / B mix audio output RCA phono jack
• Separate Channel A and Channel B volume controls
• 2 IR Sensor coaxial inputs
• 2 IR Sensors supplied, with 20 ft. and 35 ft. connecting cables and wall mounts; each
sensor with a Multiple Array of Wide-Angle Infrared Sensitive LEDs
IRW-HT6X HANDHELD MICROPHONE TRANSMITTER
• Multiple emitter array of high efficiency infrared emission LEDs for optimum IR
transmission
• Power On LED
• Powerful uni-directional dynamic cartridge for optimum audio, minimal handling noise,
and maximum feedback rejection; rugged steel mesh ballscreen with anti-roll ring
• Operates up to 5 hours on 2 alkaline AA batteries or NiMH rechargeable batteries
IRW-LT6X BODY-PACK TRANSMITTER
• Multiple emitter array of high efficiency infrared emission LEDs for optimum IR
transmission
• Power O N LED
• Channel A / B selector switch
• 3.5mm mini-jack for connection of lapel microphone
• Audio input volume control
• Belt Clip and neck worn lanyard
• Operates up to 5 hours on 2 alkaline AA batteries or 2 NiMH AA rechargeable batteries
(1) Power LED Indicator
(2) Power Switch
(3) Battery Charging DC Input Jack
(4) IR Emitter
(5) Microphone Input Jack
(6) Volume Control
(7) Belt Clip
(8) Battery Compartment Cover
(9) Channel Selector Switch
(10) LM-14 / O Lavalier / Lapel Microphone
IRW-LT6X BODYPACK TRANSMITTER
(1)
(5)
(2)
(9)
(8)
(10)
(4)
(6)
(7)
1. Transmitter Set-up
Slide down the
Battery Compartment Cover (8), as shown, exposing the battery
compartment. Insert 2 fresh AA alkaline batteries, NiMH rechargeable batteries, or the
optional IR-BBP battery pack while observing the correct polarity as marked. Set the
Channel Selector Switch (9) to the desired channel of operation and slide the cover back
into position on the unit.
(Note: Make sure the transmitter is off when changing the
batteries.)
2. Operation
a. The IRW-LT6 is provided with a 3.5mm
Locking Jack (5) for connecting the
microphone. Plug in either the
LM-14/O Lavalier/Lapel Mic (10) as supplied.
To secure the connection, turn the metal slip ring on the plug clockwise to thread it on
the jack. To unplug, reverse the process. Clip the transmitter to your clothes / belt, or
hang the transmitter on your chest using the supplied neck worn lanyard. Make sure
the IRW-LT6X
Emitter (4) has a clear line of sight with the IR Sensor. To use the
lavalier mic, attach it at upper chest level. Do not place the mic too close to the mouth
— a distance of about 6" usually works best.
(3)