Nady Systems LINK 2 Owner's Manual

Other manuals for LINK 2: Owner's Manual, Owner's Manual
Manual is about: XR PRO SERIES, VHF DigiTRU Diversity System

Summary of LINK 2

  • Page 1

    Nady xr-61 vhf digitru diversity™ system xr pro series wireless microphone system owner’s manual.

  • Page 2

    Thank you for purchasing a nady xr pro series xr-61 diversity wireless microphone system and congratulations on your choice. Also available is the xr-62, which is a single rackmount unit with dual receivers for operation of 2 channels simultaneously. The xr pro series systems are loaded with top pro...

  • Page 3

    Xr-61 receiver 1. Rackmounting the receiver the xr-61 receiver is supplied with rack ears (1) which can be attached with the screws provided on the front of the side panels to enable rackmounting the receiver. (note: do not mount the receiver in a rack directly above an amplifier or other source of ...

  • Page 4

    Xr-61 receiver 1 6 8 9 4 13 1 6 11 3 12 10 7 2 5 5 7 5. Connecting the audio output the xr-61 receiver provides both a fixed mic level balanced audio output xlr (10) and an adjustable line level unbalanced audio output 1/4” jack (11). The level from the unbalanced output is controlled by the rear pa...

  • Page 5

    21 20 17 21 20 18 19 17 9 1. Unscrew the battery compartment cover (17) and remove, exposing the battery holder (18) . Insert a fresh 9v alkaline battery (19), observing the correct polarity as marked, and screw the cover back on to the microphone. Make sure the cover is screwed on completely. A fre...

  • Page 6

    25 22 24 29 28 27 22 23 26 11 opening battery compartment 1. Snap open the battery compartment (22) and insert a fresh 9v battery (23), observing the correct polarity. Close the compartment. 2. The wlt-15 is provided with a 3.5 mm locking jack (24) for connecting the micro- phone. Plug in either the...

  • Page 7

    31 30 30 32 33 34 32 35 13 opening battery compartment 1. Snap open the battery compartment (30) and insert a fresh 9v battery (31), observing the correct polarity. Close the compartment. The wgt-15 is provided with a 3.5 mm locking jack (32) for connecting the instrument cable (35). To secure the c...

  • Page 8

    4. Microphone operation a. Turn on the link 2 by sliding the on/standby/off switch (41) to the standby position (transmitter on, audio muted) or the on position (transmitter and audio both on). The low battery indicator led (40) will give a single quick flash, indicating usable battery strength. In ...

  • Page 9

    38 43 41 44 42 40 39 45 36 37 xlr connector – connects microphone to the transmitter module for signal input locking ring – locks microphone to the transmitter optional pouch – for lavalier bodypack operation (with beltclip and strap ring for securing) gain control switch – adjusts the input sensiti...

  • Page 10

    Nady systems, inc. • 6701 shellmound street, emeryville, ca 94608 tel: 510.652.2411 • fax: 510.652.5075 • www.Nadywireless.Com nady wireless systems are type accepted under fcc rules parts 90, 74, and 15. This device complies with rss-210 of industry & science canada. Operation is subject to the fol...