Nady Systems MGT-16 Owner's Manual - page 7
Quick MHT-16 User Controls/Connections Guide
7
MH-16 Saxophone (Horn) Instrument Transmitter
28. BATTERY COMPARTMENT COVER To cover AAA battery, slide to open
29. BATTERY Single AAA alkaline or NiMH battery required for operation
30. BATTERY COMPARTMENT Insert one AAA battery, observing correct polarity
31. IR RECEPTOR SENSOR/WINDOW Infrared LED sensor for linking the TX to the RX
during IR frequency download (See also ASC
TM
IR Sync Download section, page 6)
32. POWER & LOW BATTERY LED Flashes once at power up, continuous flashing
indicates battery needs replacement
33. ANTENNA Permanently attached flexible antenna
34. INTERNAL AUDIO LEVEL ADJUST Remove battery to access slot and adjust internal
trim-pot with small screwdriver for optimal input level setting.
Note: This is to be done only in rare cases as factory level setting is already optimized for
most horns and 15dB Pad also available.
Note: Set control carefully. If trim-pot is turned past minimum and maximum adjustment
points it may need to be backed up to achieve desired setting.
35. POWER SWITCH Slide in arrow direction to power transmitter On
36. 15dB ATTENUATION PAD Select to reduce the input gain by 15dB for higher level
audio input signals
37. MOUNTING SCREW To secure the transmitter onto the bell of the horn
38. INPUT MIC For unidirectional pickup of horn’s sound