Nady Systems MPA-400 Owner's Manual

Other manuals for MPA-400: Owner's Manual
Manual is about: Wireless Megaphone P.A.

Summary of MPA-400

  • Page 1

    Mpa-400 wireless megaphone p.A. Owner’s manual.

  • Page 2

    Contents introduction ....................................................................................2 system features .............................................................................3 mpa-400 user controls and connections ............................4 transmitter user controls and...

  • Page 3

    Battery fuse 3a/250v ac~110v–230v frq. 50hz/60hz —in dc 12v+ mpa-400 wireless portable megaphone mic/wireless tone power charging low battery power mic in 4 1. Receiver antenna extend fully for optimum range 2. Handle/shoulder strap for transporting the mpa-400 3. Handle 4. Tone control counter-cloc...

  • Page 4

    6 system operation and setup powering the mpa-400 turn on the unit using the power on switch (9). The power on led (12) indicating the mpa-400 is receiving power. The mpa-400 is powered internally by the 12v/3.3a rechargeable battery. A fully charged battery can power the unit for up to 2 hours of n...

  • Page 5

    8 system operation and setup note: if using more than one wireless microphone on the same frequency, switch only one on at a time. Microphones on the same frequency will interfere with each other. However, one wireless microphone can be used with two or more mpa-400 wireless receivers on the same fr...

  • Page 6

    10 audio power output: 40w maximum, 6 ohms internal battery: built-in 12v/3.3a (rechargeable battery) external power: 12vdc 3a dc supply built-in charger: 100~240vac/50~60hz ac power consumption: 40 va dimension: 7” x 9” x 11.5” (178 x 229 x 292mm) and weight: 12.4 lbs. (5.63 kg.) input sensitivity ...

  • Page 7

    Nady wireless systems are type accepted under fcc rules parts 90, 74 and 15. This device complies with rss-210 of industry & science canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference recei...