Nady Systems PEM-1000 Owner's manual - page 3
5
Quick User Control Guide
Transmitter Front Panel
1. Earphone Output 1/4” jack: Connecting stereo earphones for monitoring output signal
2. Volume Knob: Adjusting the volume clock-wise (MAX), counter clock-wise (MIN)
3. Left/Right Source Audio Input Level LCD tree: Indicates if audio input source level is optional
4. LCD display: Displaying Channel/Frequency, and other status
5. Infrared Receptor/Sender LED: Synchronizes operatingnfrequency between transmitter and receiver as
selected by either
6. Manual UP selecting button: Manual setting up with up direction
7. Set Up Button: Set up the functions of the transmitter/ scroll through the menu list
8. Manual DOWN selecting button: Manual setting up with down direction
9. SYNC Button: Press this button down can set up the transmitter and receiver’s infrared link and
connection
10. Power Switch: Press momentarily to turn ON and for a few seconds to turn unit OFF
Transmitter Rear Panel
11. Transmitter Antenna BNC connector: Connect antenna before use
12 Left Channel Loop Out: 1/4” jack provides parallel unbalanced pass-through output of input source signal
to other devices
13. Right Channel Loop Out: see above
14. Left Channel Audio Source Input: Combo XLR/1/4” jack, mono
15. Right Channel Audio Source Input: Combo XLR/1/4” jack, mono
16. DC Input Jack: Connects AC/DC adapter power supply (center of jack is + polarity)
6
Bodypack Receiver
17. Power and Volume Control: Combo power ON/OFF switch and earphones volume adjust
18. Earphone Out: 1/8” (3.5mm) jack for connecting monitoring earphones
19. Antenna: permanently attached
20. RF Signal LED Indicator: Lights RED when receiving transmitter’s signal
21. LCD Display: Displays selected frequency and battery life status (0 Bar=Empty)
22. Infrared Receptor/Sender LED: Synchronizes operating frequency between transmitter and receiver as
selected by either
23. Stereo/Mono Switch: Selects either stereo or mono output to earphones
24. Limiter Switch: Select to limit the audio output level to earphones
25. Battery Compartment: Holds 2 x AA Betteries
26. Battery Compartment Door: Covers batteries and selection buttons
27. LOCK Button: Locks the receiver controls to prevent accidental adjustment
28. SYNC Button: Press to download receiver’s Autoscan selected frequency to receiver via infrared link for
frequency synchronization
29. AUTOSCAN: Press to automatically find open channel
30. MUTE Button: For muting the audio output to the headphone
31 . Belt Clip: Rotates 180o for attaching to belt with receiver’s top panel in either up or down position