Pmx series o w n e r ’ s m a n u a l powered mixers pmx-600 — 6 channel powered mixer w/dsp effects pmx-1600 —16 channel powered mixer w/dsp effects.
2 pmx series powered mixer with dsp effects congratulations on your choice of the nady audio pmx series powered console mixer — you have purchased one of the finest powered mixing units on the market today. This unit was developed using the expertise of professional sound engineers and working music...
Wa r n i n g 3 important safety instructions when using this electronic device, basic precautions should always be taken, including the following: 1. Read all instructions before using the product. 2. Do not use this product near water (e.G., near a bathtub, washbowl, kitchen sink, in a wet basement...
I n s ta l l at i o n 4 to ensure years of enjoyment from your nady audio pmx series, please read and understand this manual thoroughly before using the unit. Inspection your nady audio pmx series powered mixer was carefully packed at the factory in packaging designed to protect the units in shipmen...
5 c o n t r o l s a n d c o n n e c t i o n s (1) 1. Channel section (1) mic input this electronically balanced xlr input is designed to accept signals from any balanced or unbalanced low impedance (low z) microphone. To accommodate condenser microphones, this input is also equipped with +48vdc phan...
C o n t r o l s a n d c o n n e c t i o n s 6 (5) channel peak led the peak led illuminates when a channel input is overloading. It detects the peak level after the equalizer controls (7) and will light just before clipping to warn that the signal is approaching overload. You do not want the peak le...
7 c o n t r o l s a n d c o n n e c t i o n s 2. Aux effects section (14) aux send 1 & 2 level controls these controls adjust the final mixed level of the channel aux 1 and aux 2 auxiliary signals separately. These signals are then sent to the aux send 1 & 2 outputs (30) respectively. These signals ...
C o n t r o l s a n d c o n n e c t i o n s 8 4. Master input / output section (30) aux send 1 & 2 outputs these mono unbalanced 1/4” jacks output the auxiliary signals which can be adjusted by the aux send 1 & 2 level controls (14). (31) aux return 1 & 2 inputs these mono unbalanced 1/4” jacks enab...
9 c o n t r o l s a n d c o n n e c t i o n s 5. Rear panel (37) speaker outputs • right - these two 1/4” speaker output jacks are paralleled together for the master right output signal and can deliver up to 200w rms to a 4 Ω load. • left - these two 1/4” speaker output jacks are paralleled together...
C o n n e c t i o n s 10 efx tape/disk recorder or use separate cable 8 Ω 8 Ω 8 Ω 8 Ω monitor speakers & power amp reverb pa or recording device.
S p e c i f i c at i o n s the specifications above are correct at the time of printing of this manual. For improvement purposes, all specifications for this unit, including design and appearance, are subject to change without prior notice. 11 1. Input section input connector input impedance max lev...
Nady systems, inc. • 6701 shellmound street, emeryville, ca 94608 tel: 510.652.2411 • fax: 510.652.5075 • nady.Com service for your nady audio product (u.S.) should your nady audio product require service, please contact the nady service department via telephone at (510) 652-2411, or e-mail at servi...
