Nady Systems PSS-150 Owner's Manual - Specifications
OUTPUT POWeR
75watts MSperchannelinto4Ohmsload
OVeRLOAD PROTeCTION
AMA™(AutomaticMaximumAmplitude)servosystemlimitsthepoweramplifierinputto
preventclippingdistortionthatcandamagespeakers
FReQUeNCY ReSPONSe
40Hzto20KHzmeasuredat1watt
TONe CONTROLS
Bass:100Hz±+/-10dB;Treble:10KHz+/-10dB
GRAPHIC eQUALIZeR
5bands;100Hz,350Hz,1KHz,3KHz,and8KHzwithFLI™(FeedbackLocatingIndicators)
DSP eFFeCTS
Hall/ oom/Plate everbs,Chorus,Flanger,Delay,VocalCancel,Chorus/ oom, otarySpeaker
INPUT IMPeDANCe
Micinput:2KOhms,Lineinput:12KOhms
MAX GAIN
86dBmicinputtospeakeroutput
DISTORTION
Lessthan0.8%THDatratedoutput
SIGNAL / NOISe RATIO
85dBmicinputtypical
ReVeRB/DeLAY
DSPdigitalreverbanddigitaldelay
SPeAKeRS
Woofer10”(254mm)andpiezoelectrichorntweeter
AC POWeR
120VAC(60Hz)or230VAC(50/60Hz)
DIMeNSIONS
27.6”x15.75”x23.4”(70.2cmx40cmx59.4cm)
WeIGHT (assembled)
59.4lbs(27Kg)
MICROPHONe
Unidirectional(cardioid)dynamic
(18)
(16) (17)
(19)
(16) FUSe HOLDeR & POWeR CORD CONNeCTOR
ThisfuseholdercontainsanACprimaryfuse.Whenthisfuseblows,
replaceitwiththesametypefuse,sizeandpowerrating(see
SPECIFICATIONS).Ifitcontinuouslyblows,stopreplacingthefuse
andreferservicingtoqualifiedpersonnel.Thecordconnectoris
usedtoconnecttheACpowersourcetoyourpoweramplifier.
(CAUTION: After checking the AC supply voltage, be sure that the correct
fuse is in the fuse holder.)
(17) AC VOLTAGe SeLeCT SWITCH
Beforeplugginginthepowercord,checktoseethattheunitisset
forthepropervoltageforyourarea:~115V(60Hz)or~230V(50Hz).
(Note: use at the improper voltage can damage your unit and void the
warranty.)
(18) POWeR SWITCH
UsethisswitchtopowerunitONorOFF.Beforeturningonthis
unit,verifyconnectiontothepropervoltageACsource,checkall
connectionsandturndownthelevelcontrolsofequipmentconnected
totheoutputs.
(19) SPeAKeR 1/4” OUTPUT JACKS
ConnecttotheleftandrightPSS-150speakers.
7
Rear Panel Controls & Connections