U u--1 10 00 00 0 s se er riie es s 1000 channel pll frequency synthesized uhf wireless microphone and instrument system o w n e r s m a n u a l n a d y . C o m.
Table of contents introduction ................................................................................................2 system features..........................................................................................3 operating instructions ............................................
System features u-1000 receiver (single channel) and u-2000 receiver (dual channel) • unsurpassed uhf performance with 120 db dynamic range and operation up to 500 feet line-of-sight • rugged 19” 1u rackmountable uhf-1000/2000 receiver with dual removable antennas (for convenient front panel placeme...
Specifications 21 input impedance ........................................Uh-1000: 10 k ohms ub-1000: 500 k ohm (instr.), 10 k ohms (lav), 20 k ohms (hm) controls ......................................................Uh-1000: on/off switch, mute, set, and up or down buttons ub-1000: on/off switch, m...
20 specifications system specifications operating frequency range ....................1000 channels switchable freq. Synthesized ......................................Pll system with frequency stability frequency response ................................30 hz-15 khz ±3 db dynamic range.................
19 tips • for operation with external antenna, low loss rf shielded cable should be used and the length of the cable should not exceed 3m. • do not place the receive antenna within 1 meter of another receiver or antenna. • the receiver antenna should be kept away from any metal surface. • if the vol...
18 system operation (note: the uh transmitter cap (7) must be removed before installing the usb cable.) (note: only one transmitter can be used with one uhf-1000 receiver. It is not possible to use two transmitters on the same frequency and mix the output of these transmitters into one wireless rece...
Connecting audio output there are two audio outputs on the back of the receiver. Mic-level balanced and line-level unbalanced. Use shielded audio cable for the connection between the receiver and the mixer. If the mixer / amp is a 1/4” phone jack, connect a cable from the 1/4” unbalanced audio outpu...
16 system operation level adjustment ub-1000 transmitter the input level has four choices. “1” is the lowest gain, and “4” is the highest. For instrument, lavalier mic, and hm-1 headset mic use the normal setting of “3”. For hm-1 use setting “1”. When ready to speak, move the audio mute switch to th...
15 system operation frequency selection the transmitter and receiver must be on the same frequency to operate correctly. Use the channel frequency, or group and channel menus described in the receiver and transmitter setup instructions. Instrument connection using the ub-1000 transmitter in the “ins...
14 operating instructions ub-1000 bodypack transmitter 6. Sensitivity set level (input level sensitivity) in input level sensitivity has four choices. “1” is lowest gain, and “4” is highest gain. In the sens set level menu, hold the set (10) button for 3 seconds. The curser will blink; press the up ...
13 operating instructions ub-1000 bodypack transmitter 2. “nady ub-100” (can not be edited) 3. User name the user name field has 8 character spaces. Choose from upper and lower case alphabet, 27 special characters (including space), and 10 numbers. In the user name menu, hold the set (10) button for...
