Nady Systems U-41 QUAD Owner's manual

Other manuals for U-41 QUAD: Owner's manual
Manual is about: Four Discrete Channel UHF Wireless Microphone System

Summary of U-41 QUAD

  • Page 1

    Nady systems, inc. 6701 shellmound street • emeryville, ca 94608 tel: 510.652.2411 • fax: 510.652.5075 • www.Nady.Com service information (u.S.) if you are experiencing operation problems with your system, check out the support page on the nady website: www.Nady.Com for help and for contacting the n...

  • Page 2

    15 specifications overall system specifications frequency response .............................................................................................30hz-18khz, -3db dynamic range ................................................................................................................

  • Page 3

    14 • the receiver antennas should be kept away from any metal surface. • for optimum operation with external antennas use only low loss rf shielded cable no longer than 10’ (3m) in length. • if the volume control of the receiver is set too high, it may over-drive the input of the mixer or pa, causin...

  • Page 4

    4 u-41 quad receiver rack-mounting the receiver the nady u-14 quad uhf receiver has built-in brackets for rackmounting. Simply attach the unit to the rack with supplied screws. (note: do not mount the receiver in a rack directly above an amplifier or other source of high heat. This could degrade the ...

  • Page 5

    12 receiver volume controls adjust the volume controls work only for the 1⁄4” sum (mix) output. Turn volume controls (5) on the u-41 quad receiver clockwise to near full gain. Adjust volume up or down so that no audio distortion is present when amplifier or mixer is set at their usual levels. At full...

  • Page 6

    6 u-41 quad receiver 5 7 3 9 1 2 11 link-4™ snap-on transmitter transmitters set up the link-4 transmitter requires a single 9v battery to operate. To open the battery compartment, slide the battery door (31) downward to open the cover, exposing the battery holder (32). Insert a fresh 9v battery acc...

  • Page 7

    7 uh-4 handheld transmitter transmitters set up the uh-4 transmitter requires a single 9v battery to operate. To open the battery compartment, unscrew and remove the battery cover (16) , exposing the battery holder (17) . Insert a fresh 9v battery according to the correct polarity as indicated on th...

  • Page 8

    9 ub-4 bodypack transmitter the ub-4 is equipped with two input selector switches (27) located under the cover on the circuit board for selecting the type of audio input you will be supplying to the transmitter. Select from the choice of three positions: instrument (for guitar, bass, etc.)/ headworn...