Nady Systems UB-10 Owner's Manual

Other manuals for UB-10: Owner's Manual

Summary of UB-10

  • Page 1

    Owner's manual ub-10 bodypack transmitter urr-10 receiver uh-10 handheld microphone uhf wireless microphone system nady systems, inc. 6701 shellmound street emeryville, ca 94608 usa tel: 510.652.2411 • fax: 510.652.5075 e-mail: service@nadywireless.Com www.Nadywireless.Com urr-10

  • Page 2

    14 3 nady wireless systems are type accepted under fcc rules, parts 90, 74 and 15. This device complies with rss-210 of industry & science canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference; and (2) this device must accept any interferenc...

  • Page 3

    4 13 thank you for purchasing a nady urr-10 diversity wireless microphone system and congratulations on your choice. The urr-10 is the best performance and price value available in rackmount uhf wireless systems and is loaded with features: • clear channel operation on the wide open, uncluttered uhf...

  • Page 4

    12 5 1. Rackmounting the receiver the urr-10 is supplied with rack ears (17) which can be attached with the screws provided on the front of the side panels to enable rackmounting the receiver. (note: do not mount the receiver in a rack directly above an amplifier or other source of high heat–this co...

  • Page 5

    6 11 5. Connecting the audio output the urr-10 receiver provides both a fixed mic level balanced audio output xlr (14) and an adjustable line level unbalanced audio output 1/4" jack (13) . The level from the unbalanced output is controlled by the front panel volume control (6) and the rear panel lev...

  • Page 6

    10 7 2 3 4 5 6 7 8 front panel rear panel 1 9 10 11 12 13 14 9 15 17 18 10. Fuse 11. Dc input jack 12. Level low/hi switch 13. Unbalanced audio out 14. Balanced audio out 15. 12-15 vdc adapter 16. Telescoping antennas 17. Standard rack ears 18. Fr-2 front-antenna rack kit (optional) 1. Front panel 2...

  • Page 7

    8 9 1. Unscrew the battery compartment cover (19) and remove, exposing the battery holder (20) . Insert a fresh 9v alkaline battery (21), observing the correct polarity as marked, and screw the cover back on to the microphone. Make sure the cover is screwed on completely. A fresh alkaline battery ca...