Nady Systems UHF-7 Owner's Manual

Summary of UHF-7

  • Page 1

    Owner's manual nady wireless systems are type accepted under fcc rules parts 90, 74 and 15. The device complies with rss-210 of industry & science canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any inte...

  • Page 2

    Contents ...........................................................................................2 introduction ....................................................................................2 using this manual............................................................................2 syst...

  • Page 3

    10 3 uhf-7 receiver • unprecedented value in a full-featured single-channel uhf wireless mic system — with interference-free operation in any application or locale on select uhf frequencies within separate bands 902-928 and 944-952 mhz • half-rack receiver design with folding front panel dual antenn...

  • Page 4

    4 1. Rackmounting the receiver there are 2 options available for rackmounting the uhf-7 receiver: singly or side-by- side with another uhf-7 series receiver. A. Single mounting: remove the receiver side mount clip (1) from each side of the receiver (as shown) and slide in the optional erm-12 rack ea...

  • Page 5

    8 1. Snap open the battery door (22) and insert a fresh 9v alkaline battery into the battery compartment (23) , observing the correct polarity. Fresh alkaline batteries can last up to 10 hours in use, but in order to ensure optimum performance, it is recommended that the battery be replaced after 6-...

  • Page 6

    7 1. Unscrew the battery compartment cover (16) and remove, exposing the battery holder (17 ). Insert a fresh 9v alkaline battery (18), observing the correct polarity as marked, and screw the cover back on to the microphone. Make sure the cover is screwed on completely. Fresh alkaline batteries can ...