Nady Systems WA-125U Owner's manual

Summary of WA-125U

  • Page 1

    Nady systems, inc. 6701 shellmound street • emeryville, ca 94608 tel: 510.652.2411 • fax: 510.652.5075 • www.Nady.Com service information (u.S.) if you are experiencing operation problem with your system, check out the support page on the nady website: www.Nady.Com for help and for contacting the na...

  • Page 2

    15 specifications amplifier specifications audio output power ......................................................................................................... 20w (max) speaker load ........................................................................................4 ohms (6-1/2 inch sp...

  • Page 3

    14 3 system features wa-125u receiver/amplifier • powerful 20w audio output • operation in the wide-open, uncluttered upper uhf band (available on single frequencies in range 797-805mhz) for optimum operating range and freedom from interference • built-in echo/reverb • 1/4” unbalanced input jacks: 1 ...

  • Page 4

    On rf on mic/tx echo power mic mic aux aux treble rec. Out bass wa-125u uhf wireless amplifier 4 wa-125u controls & connections 1. Power on/off switch 2. Mic and aux signal input jacks 3. 6.5” round speaker 4. Power on led indicator 5. Rf on transmitter signal reception led indicator 6. Mic/tx, mic,...

  • Page 5

    12 5 wa-125u controls & connections 10. Charging led indicator for transmitter 9v rechargeable battery 11. Battery charger connector for one 9v transmitter battery 12. Ac power adaptor input socket 13. Ac adaptor input fuse 14. Mounting hole for use with optional mst-4b aluminum tripod stand 15. Bat...

  • Page 6

    6 wa-125u operating instructions 11 powering the wa-125u ac power (12): plug the ac adaptor to a wall outlet then insert the plug into the ac power adap- tor input socket (note: before connecting to ac power, make sure the working voltage of your wa-125u, either 115v ac or 230 v ac, as supplied and ...

  • Page 7

    Same frequencies that can possibly affect the sound even while the mic transitter is on and being used). In normal operation, the rf mute (squelch) trimpot (18) should be set clockwise fully to the factory setting (max. Range). However, in areas of high rf activity, the rf mute (squelch) trimpot (18...

  • Page 8

    9 8 uh-4 handheld microphone transmitter uh-4 handheld microphone transmitter transmitters set up the uh-4 transmitter requires a single 9v battery to operate. To open the battery compartment, unscrew the battery cover (22) with a counter-clockwise turn and remove the cover, exposing the battery hol...