Nady Systems WGA-15 Owner's Manual - Quick User Controls Guide
Quick User Controls Guide
wGa-15 15w wireless Guitar amp
System Features
wGa-15
15w wIreless GuITar aMP
Versatile, powerful practice amp
•
with 15W RMS output
6” speaker
•
Gain control; Volume with killer
•
distortion; Treble and bass controls;
Headphone output
Built-in VHF receiver with Receiver
•
On and Audio Received LEDs
wGT wIreless BODYPaCK
TransMITTer
Wireless instrument bodypack
•
transmitter with up to 250 feet
typical operating range (depending
on site conditions)—up to 500+
feet line-of-sight
Proprietary companding circuitry
•
for an industry-best 120dB
Dynamic Range, and the clearest,
most natural sound available
Noise-free transmitter
•
On/Off operation
Off/Standby/On switch allows
•
convenient audio muting with
the transmitter “On”
Low battery LED indicator flashes
•
once for unit “On”; lights steady
for low battery alert
Locking 3.5mm mini-jack
•
provides secure connection
for instrument cable
Easily accessible input level
•
adjust control for optimal sound
Instrument cable included
•
1. POWER LED Lights red to indicate
the power is on
2. POWER SWITCH Turns on power to the
amplifier. Make sure unit is plugged
into AC and the Level control is turned
down before turning on the amp.
3. INPUT JACK Use this jack to plug in
the guitar cord when not in wireless
operation. Plugging into this jack will
automatically disable the wireless
receiver capability.
4. GAIN CONTROL This control adjusts the
input gain of the guitar audio. Turn this
control to minimum for clean sounding
guitar. Turn it to maximum for heavy
distortion. Blues-style distortion can
be achieved by setting this control
to mid-level.
5. LEVEL CONTROL This control adjusts the
final master volume of the audio.
6. TREBLE CONTROL This control adjusts
the treble frequencies (approximately
5K Hz) to increase high cut, presence,
and add definition to your sound.
7. BASS CONTROL This control adjusts
the bass frequencies (approximately
120 Hz) for warmer sound and stronger
low end.
8. PHONE JACK This jack should be
used for headphones. When plugging
into this jack, the internal speaker
is disabled.
Note: this jack is meant to receive a
stereo headphone ¼” TRS plug. Do not
plug a mono ¼” TS plug into this jack.
9. AUDIO LED Lights amber to indicate
audio is present on received TX signal.
10. TX LED Lights green to indicate the
guitar transmitter is on, within range,
and the RF signal is being received.
11. ANTENNA The antenna wire is dressed
inside the amp cabinet. Do not remove
or reposition this wire.
INPUT
PHONE
POWER
3
ON
TX
AUDIO
0
10
0
10
0
10
GAIN
LEVEL
TREBLE
BASS
0
10
4
5
6
7
8
1
2
9
10
11
2