Nagel 2S Trimmer Installation Manual - 2. General

© Ernst Nagel GmbH                    2S Trimmer Installation Manual en.doc               Rev.1.0.          16.11.2010 

 5 

2. General  

With the addition of the 2-Side Trimmer to the NAGEL product range, a cost effective full-bleed solution is 

available which has a small footprint and is easily to operate. This machine is designed with high reliability in 

mind, which means that it has been designed for long run production. 

The main goal of the 2-Side Trimmer, further referred to as STR, is that it can be used for trimming the bleed 

off the booklet. Booklets with a maximum up to 25 sheets 80g/m2 (50 folded)

can be trimmed from 2mm to 

35mm on each short edge of the booklet, to a minimum of 200mm and a maximum of 320mm finished size. 

Thereby it is also possible to trim asymmetrical. All actions concerning operating the STR and adjusting the 

trim settings can easily be done by using the User Interface (UI) on the STR. 

For example in the schedule mentioned below is schematically rendered some results which are possible 

with the STR by using a different Center Offset (symmetrical or asymmetrical): 

Centre Offset: 

15mm

Centre Offset:  

-15mm

Centre Offset: 

0mm 

33,5mm Waste 

33,5mm Waste

3,5mm Waste

18,5mm Waste 

3,5mm Waste 

Finished Size:  

260.0mm

Infeed Size:  

297.0mm

18,5mm Waste