Nagra PORTABLE ANALOGUE AUDIO TAPE RECORDER Instruction Manual - page 54
FILTERS
LFA 1 (low frequency
Attenuation
attenuation)
4 dB at 50 Hz
LFA 2
8 dB at 50 Hz
HP 1 (high-pass)
10 dB at 50 Hz
HP 2
20 dB at 50 Hz
HP 1 + LFA 1 (combination)
14 dB at 50 Hz
REFERENCE GENERATOR
1.1 kHz sine wave signal with 10 kHz component
0 VU level= -8 dB ±0.1 dB
OUTPUTS
Line output voltage on 600 Ohm for 0 dB on the modulometer 4.4 V
Line output impedance
at 30 Hz
90 Ohm
at 50 Hz
42 Ohm
at 1 kHz 18 Ohm
at 15 kHz 24 Ohm
Maximum output voltage on 600 Ohm,
for 1% distortion
at 1 kHz
10,5 V
at 5 kHz
10,5 V
at 30 Hz 7,0 V
Headphones output voltage on 50 Ohm, adjustable from 20 to 500 mV
Output voltage at MIXER connector, on 100 k Ohm, for 0 dB on the modulometer 560 mV
Output voltage of the pilot signal
with QSLI synchronizer
1 V
without synchronizer
350 mV
BUILT-IN LOUDSPEAKER
Power output of the amplifier
1 W
OPERATING CONDITIONS
Temperature
with manganese batteries
- 4 to + 160 degrees F
-20 to + 72 degrees C
with external power
-67 to + 160 degrees F
-55 to + 71 degrees C
The recorder operates correctly in any position.