Summary of nait 5
Page 1
O w n e r s m a n u a l i n t e g r a t e d a m p l i f i e r.
Page 2: 1.0 Equipment Installation
Page 1.0 equipment installation normally your naim equipment will have been installed by the dealer who sold it to you even if you live outside their immediate vicinity. Your dealer is responsible for making sure that the system sounds exactly as it should and information given here is not intended ...
Page 3: 2.0 Getting Started
2.0 getting started 2.1 switching on and off source components and power supplies for cd players, tuners, preamplifiers and crossovers should be switched on before switching on the amplifier(s). Always switch the amplifier(s) off and wait about a minute for its power supply capacitors to discharge b...
Page 4: 3.0 Warnings
Important in order to comply with current european safety regulations it is essential that the naim loudspeaker connectors supplied with amplifiers and loudspeakers are used. Do not under any circumstances allow anyone to modify your naim equipment without first checking with the factory, your deale...
Page 5: 4.0 Connection
4.0 connection 4.1 mains lead as the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: the wire which is coloured green-and-yellow must be connected to the terminal in the plug which is ma...
Page 6: Nait 5 Integrated Amplifier
5 nait 5 integrated amplifier inputs the nait 5 has 6 inputs - cd, tuner, tape, a/v, aux1 and aux 2. Tape, a/v and aux 1 all have record output facilities for your cassette deck, vcr etc. The aux 2 input is provided with two sockets. Use the right hand socket (when viewed from the rear) for commenti...
Page 7: Nait Series 5
6 ch1 ch1 ch 2 -ve ch 2 tape, a/v, aux 1, inputs ch1 nc nc -ve ch 2 cd, tuner & aux 2 inputs +vin +vin ch1 -ve ch 2 signal out a mute mon cd tuner tape a/v aux 1 aux 2 nait series 5 front nait series 5 rear mains input power volume to left loudspeaker ch1 to right loudspeaker ch2 link plugs fitted +...
Page 8
Nait 5 connected to power supply mains input power to left loudspeaker ch1 to right loudspeaker ch2 + - - + input signal out a signal out b cd tuner tape a/v aux 1 aux 2 mains input power flatcap 2 power supply cable direction marker 4 to 4 pin din 5 to5 pin din interconnect cables 7 signal out a po...
Page 9
8 nait 5 connected to power amp nb - do not connect nait 5 to mains in this configuration. Power amp + - - + input signal out a signal out b cd tuner tape a/v aux 1 aux 2 input cable direction marker 4 to 4 pin din 5 to5 pin din interconnect cables mains input power to left loudspeaker ch1 to right ...
Page 10
9 nait 5 connected to flatcap 2 power supply & power amp nb - do not connect nait 5 to mains in this configuration. + - - + input signal out a signal out b cd tuner tape a/v aux 1 aux 2 mains input power flatcap 2 power supply power amp signal out a power out a signal out b signal out c cable direct...
Page 11: Narcom 2 Remote Handset
1 0 n 2 narcom 2 remote handset narcom 2 is a multi-functional remote control handset designed to be used with naim audio cd players, integrated amplifiers, pre-amplifiers and preset tuners. The handset control configuration is based around three types of keys: system component keys, global keys and...
Page 12
1 1 3 soft keys these keys operate functions depending on the system component key setting. Numeric keypad: in preamp mode the numeric keys will switch between the amplifier inputs (1 - cd, 2 - tuner, 3 - tape, 4 - av, 5 - aux 1, 6 - aux 2). In cd mode the numeric keys will select tracks. In tuner m...
Page 13: Appropriate Standards
1 2 naim audio southampton road salisbury england sp1 2ln tel: +44 (0)1722 332266 www.Naim-audio.Com ownit • issue 3 • may 2001 ec declaration of conformity to appropriate standards manufacturer naim audio limited southampton road salisbury england sp1 2ln products nait 5 integrated amplifier nap 17...