Summary of STAGELINE
Page 1
O w n e r s m a n u a l s t a g e l i n e p h o n o s t a g e.
Page 2
Page 2 1.0 equipment installation 1.1 cables and connections 3 2.0 getting started 2.1 switching on and off 2.2 running in 2.3 mains supply 4 2.4 siting the equipment 2.5 if you have a problem 5 3.0 warnings 7 4.0 connection 4.1 mains lead 4.2 non-rewireable mains plugs 4.3 fuse carrier 4.4 plug fus...
Page 3: 1.0 Equipment Installation
2 1.0 equipment installation normally your naim equipment will have been installed by the dealer who sold it to you even if you live outside their immediate vicinity. Your dealer is responsible for making sure that the system sounds exactly as it should and information given here is not intended to ...
Page 4: 2.0 Getting Started
3 2.0 getting started 2.1 switching on and off source components and power supplies for cd players, tuners, preamplifiers and crossovers should be switched on before switching on the amplifier(s). Always switch the amplifier(s) off and wait about a minute for its power supply capacitors to discharge...
Page 5
2.4 siting the equipment power supplies and amplifiers should be located a reasonable distance away from other equipment. This separation will stop transformer radiation causing hum audible from the loudspeakers. The minimum recommended distance is 300mm (12 inches), and that allowed by the standard...
Page 6: 3.0 Warnings
5 3.0 warnings naim equipment is designed to offer the finest sound quality that can be achieved, avoiding compromise wherever possible. This can lead to circumstances that may be unfamiliar. The material that follows contains advice specifically related to naim equipment as well as more general war...
Page 7
Important in order to comply with current european safety regulations it is essential that the naim loudspeaker connectors supplied with amplifiers and loudspeakers are used. Do not under any circumstances allow anyone to modify your naim equipment without first checking with the factory, your deale...
Page 8: 4.0 Connection
7 4.0 connection 4.1 mains lead as the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: the wire which is coloured green-and-yellow must be connected to the terminal in the plug which is ...
Page 9: Note
Note this equipment has been tested and found to comply with the relevant emc and safety standards, and, where applicable, also complies with the limits for a class b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful inte...
Page 10: Stageline Phono Stage
9 stageline phono stage stageline is a separate phono stage suitable for one type of cartridge, either moving magnet or moving coil. Please confirm the type required with your dealer at time of purchase. Stageline can be powered either by a separate flatcap or hi-cap, or from the dedicated supply bu...
Page 11
10 +vin +vin ch1 -ve ch 2 output mains input power to left loudspeaker ch1 to right loudspeaker ch2 link plugs fitted + - - + input signal out a signal out b cd tuner tape a/v aux 1 aux 2 stageline connected to nait 5 ch2 right ch1 left ground output cable direction marker 5 to5 pin din interconnect...
Page 12
11 to left loudspeaker ch1 to right loudspeaker ch2 + - - + input signal out a signal out b cd tuner tape a/v aux 1 aux 2 mains input power flatcap 2 power supply signal out a power out a signal out b signal out c signal out d stageline connected to nait 5 with power supply ch2 right ch1 left ground...
Page 13: Ec Declaration
1 2 ec declaration of conformity to appropriate standards manufacturer naim audio limited southampton road salisbury england sp1 2ln products stageline, nait 5, flatcap 2 power supply safety hd 195-s6 en 60 065 emc emissions tested to en 55013 sound and television broadcast receivers and associated ...
Page 14
Naim audio southampton road salisbury england sp1 2ln tel: +44 (0)1722 332266 www.Naim-audio.Com ownsl • issue 1 • may 2001.