Summary of EP-1060
Page 1
30 massage lounger ep1060/ep1260 instruction manual ep1060 ep1260
Page 2
33 controller part names and functions programmed operation whole back gentle strong neck roller position reclining programmed operation / manual operation lower back neck, shoulder tap on/off vibration on/off gentle strong intensity leg massage neck roller position reclining programmed operation / ...
Page 3
35 1. After carrying out safety checks, turn the unit on (see page 36) z plug the power plug into the power socket. X turn the lock switch to the “open” position. C turn on the power switch on the back of the unit. • please always check for the following before using the unit. - check that there are...
Page 4
37 caution • slowly sit down after checking the position of the massage heads. If you do not check the position of the massage heads, you may be injured or the unit may be damaged. Before sitting down • when the massage does not feel strong enough, lift up the pillow and carry out the massage again....
Page 5
39 the selected program will start • it is possible to change the program selected and the desired movement mid-way through a massage. • in programmed operation, the leg massage begins at the same time. It is possible to stop or change the intensity of the leg massage during the program. (please see...
Page 6
41 manual operation neck roller position reclining programmed operation / manual operation intensity roll manual operation whole back regional tap a vibration tap b swedish shiatsu knead position 1 3 4 1. Press the button • the on/off lamp will come on. • you can now select either strong or gentle o...
Page 7
43 • it is possible to carry out leg massage at the same time as upper body massage. • if your calves are not in the correct position in the legrest, please adjust your legs so that they are. 1. Press the button • the programmed operation and leg massage button will flash. 2. Press the leg massage b...
Page 8
45 1. Turn off the power z turn the power switch to the “off” position. X turn the lock switch to the “lock” position. Disconnect the power • always turn the power switch to the “off” position and the lock switch to the “lock” position. Failure to do so may lead to accidents if children play with th...
Page 9
47 • the movements below are shown in simplified form for the sake of illustration. • when the programs have finished the unit will automatically stop. (although programmed operation lasts for approximately 15 minutes (12–17 minutes), this will vary according to the shoulder position and program sel...
Page 10
49 this feels as though the thumbs of both hands are being used to work on the acupressure points. The initial strong push is followed by a short pause to give the impression of a professional shiatsu masseur. This type of massage is ideal for people with tight muscles and pain who want a point mass...
Page 11
51 problem cause and remedy motor noises • the motor groans when it comes under load. • there is excessive noise during tapping. (the noise is greater at the top of the unit.) • the motor sounds strange when adjusting massage intensity and width. • there is a rattling sound when the massage heads mo...
Page 12
Important safety instructions basic precautions should always be followed when using an electrical unit, including the following. Please ensure that you read all instructions before using the household massage lounger. Danger – to reduce the risk of electric shock: 1. Always unplug the unit immediat...
Page 13
Operating precautions warning: to avoid damaging the unit. 1. The seat is designed for a maximum user weight of 120k g (264lbs). Exceeding the maximum weight may cause permanent damage to the massage mechanism and/or other components of the unit. Any such damage is deemed to be user abuse and as suc...
Page 14
57 power supply: ac 230v, 50hz power consumption: 115w (approx. 5w in standby mode with the controller turned off or when the unit is turned off.) upper body massage massage area (up-down): approx. 70cm massage area (left-right): distance between massage heads during operation approx. 6 – 15cm massa...