Nakamichi ARIES 34 Owner's Manual - page 25
1.
2.
3.
4.
5.
6.
Once this has been done, press and hold the
TIMER/SLEEP button until [TIMER SET] (set
timer) scrolls on the display.
Press button on the remote control to select source.
Press
TIMER/SLEEP button to confirm. The hour digits are displayed and begin to blink.
Press button on the remote control to set hour, and then press
TIMER/SLEEP
button again. The minute digits are displayed and begin to blink.
Press button on the remote control to set minute, and then press
TIMER/SLEEP
button to confirm.
Press to adjust volume, and then press
TIMER/SLEEP button to confirm. A clock
icon appears on the display.
This unit can be used as an alarm clock. You can select DISC, USB, TUNER as alarm source.
This unit can switch to standby mode automatically after a set period.
23
Set the alarm timer
•
In standby mode, press clock button, then the clock will be shown on the display if you set
the clock correctly. If not, please refer to clock setting on page 15 to make sure the clock
can appear on the display.
Note:
•
•
The alarm timer is not available when the source is set as “AUX”.
If the USB/DISC source is selected but no device connected, the unit switches to TUNER
automatically.
Note:
/
/
/
/
Activate / deactivate alarm timer
1.
•
•
In the standby mode, press TIMER/SLEEP button repeatedly.
If timer is activated, the icon is displayed.
If timer is deactivated, the icon disappears on the display.
Set sleep timer
1.
When the unit is turned on, press
SLEEP button repeatedly to select a preset period (in
minutes).
When the sleep timer is activated, SLEEP icon “ ” displayed.
OFF
120
90
60
45
30
15
Please Note: To deactivate the sleep timer, press SLEEP button repeatedly until [off] (sleep
off) appears.