Nakamichi NA2800 User Manual - page 6
I
I
IN
N
NT
T
TR
R
RO
O
OD
D
DU
U
UC
C
CT
T
TI
I
IO
O
ON
N
NS
S
S
After connecting, when you start up the reverse gear, the unit will receive the picture from car rear view camera.
Note:
-
Only use groundless loudspeakers.
-
Use only loudspeakers of minimal 40Watt, using fewer watts may result in damaging your loudspeakers at
higher volumes.
-
Use 4~8
Ω
(Ohm impedance) loudspeakers only; using higher or lesser impedance may damage the unit.
-
Do not use 3-cable loudspeakers and do not connect the loudspeakers minus to the car body (GND). The
unit is using a BTL circuit and each loudspeaker must be connected with insulated cables according the
diagram.
-
Loudspeaker cables and/or optional external power amplifiers must always be about 30cm away from the
antenna and/or antenna extension parts.
Connect the speakers according the following diagram, incorrect connections will damage the unit or your
loudspeakers
Correct connection
Left front - Right front | Left rear - Right rear
Incorrect connections
5
Wiring Connections