1. DL manuals
  2. NAL
  3. Modem
  4. A3LA-XM
  5. Getting Started

NAL A3LA-XM Getting Started

Other manuals for A3LA-XM: General description manual
Manual is about: A3LA-XM is an Iridium satellite modem

Summary of A3LA-XM

  • Page 1

    Getting started with model a3la-xm version 1.0 may 22, 2009 copyright © 2009 by nal research corporation the specifications in this document are subject to change at nal research’s discretion. Nal research assumes no responsibility for any claims or damages arising out of the use of this document or...

  • Page 2

    Nal research corporation (tn2009-26-v1.0) 2 recommended reading materials in the following order: 1. Getting started with model a3la-xm ( tn2009-26-v1.0) 2. General description of model a3la-xm ( tn2009-25-v1.0) 3. Satterm software manual (tn2009-19-v7.0) 4. Encryption module manual (tn2009-28-v3.0)...

  • Page 3

    Nal research corporation (tn2009-26-v1.0) 3 step 4: slide the sim chip reader’s plastic bracket in the direction indicated by the arrow and lift up the bracket. Place the sim chip (facing down) into the sim bracket as shown in picture below. There is a small cut-off on one of the corners of the sim ...

  • Page 4

    Nal research corporation (tn2009-26-v1.0) 4 step 7: supply a constant dc voltage (can be at any voltage between 4vdc and 32vdc) to the power input of the hrc-24-7x, the hrc-24-7xu, the hrc-24-8x or the hrc-24-8xu. Highest current drawn will be at power-up and approximately 2.2a@5.0vdc for less than ...

  • Page 5

    Nal research corporation (tn2009-26-v1.0) 5 a useful diagnostic tool allowing the modem status to be displayed on the lcd of the handset as well as using the handset to place a voice call. Step 10: use any terminal emulator software and at commands to communicate with the modem. However, the a3la-xm...

  • Page 6

    Nal research corporation (tn2009-26-v1.0) 6 step 13: if the dpl handset is not available, use the following steps to check if the sim or the phone control is locked: 1. If using the satterm software, open the at command table for the at+cpin command and click the read button. If not using the satter...