Nanosat NANO Premium User Manual - General Information
There are two ways to program the remote control ; Automatic Code Search or Direct Entry.
I. Usnig Automatic Code Search
1) Turn on the component you want to control (TV, VCR or DVD).
2) Press and hold the component key you want to program. Holding the component key until the LED on the
remote control turns on, then release the key.- ➊
3) Point the remote at the component, press and release the ➌UP ( ) button, then wait three seconds or
until the LED stops flashing.
At this point the remote control is searching for the correct code to program. If, after three seconds, the
component you want to control does not turn off, press and release ➌UP ( ) button again to tell the
remote to search the next set of codes.
4) If the component you want to control does turn off; Press and release ➍OK Button , then the LED blinks
three times.
II. Using Direct Entry Method
1) Turn on the component you want to control (TV, VCR or DVD).
2) Locate the enclosed Code List. Find your brand of the component you want to control.
3) Press and hold the component key you want to program. Holding the component key until the LED on the
remote control turns on, then release the key.
4) Enter 3-digit code from the code list, then the LED blinks three times.
5) If you get no response, repeat these steps using the next code listed for your brand until the component
responds to the remote control command.
III. Changing Volume Lock
Locking the volume controls to a single device makes it easier to control volume, without having to guess
whether the volume will change. If you lock the remote's volume controls to the TV , you will always be able to
change the volume to the level you want, without having to adjust it on multiple devices.
If you want to lock the volume for the STB component ;
1) Press and hold the STB component key until the LED on the remote control turns on.
2) Enter 3-digit code, 9 9 9 .
3) Press and release the STB component key, then the LED blinks three times.
Unlocking volume control ;
If you want to unlock the volume for the STB component ;
1) Press and hold the STB component key until the LED on the remote control turns on.
2) Enter 3-digit code, 9 9 9 .
3) Press and release the STB component key, then the LED blinks three times.
User's Manual
9
GENERAL INFORMATION
Programing the Remote Control
Programing the RCU