NAPCO IQ PROFILER - Installation Instructions Manual - Configuring The Iq Profiler

CONFIGURING THE IQ PROFILER

LED Disable Jumper

To prevent the walk test LED from turning on, remove the jumper

from the pins labeled LED DISABLE. Removing this jumper will not

affect the flashing of the LED on self test failure.

Sensitivity Setting (SEN Jumper)

The unit is shipped with no jumper in this position. This is the normal

sensitivity mode and is recommended for most installations whose

coverage area does not exceed 30’ x 35’.  Coverage out to 50’ x

50’ is possible in this mode, but the intruder will have to cover a

larger distance before detection. To have faster catch performance

this jumper must be installed. Note: Advanced signal processing

will be defeated in this high sensitivity mode. DO NOT INSTALL

THIS JUMPER IF PETS OR RODENTS ARE PRESENT.

COMPLETING THE INSTALLATION

Allow at least three minutes for the unit to stabilize after applying

power, during this time the unit will perform its own self diagnostics

and set a baseline detection level.  The LED will flash rapidly for

approximately 1 minute and not function until the unit is ready. If the

unit was installed after being kept in a hot or cold vehicle allow the

unit to operate with its cover in place for about 15 minutes. This will

insure that the unit has measured the proper room temperature.

Walk test the unit to insure the desired coverage, making any board

height adjustments that may be necessary. Note: One common

cause of short range is having the lens in up side down, always

check this! During walk test, the unit will go into a zone finding mode

for 15 seconds after each trip. This will cause the LED to light each

time a beam is entered. To view the normal detection pattern

remain motionless for at least 15 seconds between walk tests.

13