NAPCO Magnum Alert-800 Operating Manual - page 8

SHUNT button, labeled 

 and

enter your code. The yellow

SHUNT light and the 

red ARMED/

MEMORY light will come on. The

green light will be out. All zones

programmed by your alarm spe-

cialist to respond to manual

shunting will be shunted (even if

some are not in “trouble”).

Leave quickly when the red

ARMED/MEMORY light goes on.

Be sure to have all zones in

“trouble” repaired as soon as

possible.

when 

 return

When you enter through the

exit/entry door, the entry delay

Mini-Sounder will come on.

Check the red ARMED/

MEMORY light. If it is flashing,

an alarm occurred while you were

gone. Disarm the system with

your code from the keypad to

silence the sounder. NOTE: If

your system has a digital com-

municator, there may be a delay

while it is reporting an alarm

before your system disarms.

If the red ARMED/MEMORY

light was flashing before you

disarmed, it will go out briefly

then begin to flash a number of

pulses identifying the zone(s)

that had an alarm. Write down

the number of times the alarm

memory lamp flashes, so you will

have a record of which zone(s)

need attention. You may then

arm and disarm to cancel the

flashing alarm memory. If a zone

is still in alarm condition, you

will hear the Mini-Sounder for

three seconds. The red ARMED/

MEMORY light will go out. The

green STATUS light may start

flashing if zones are still in

“trouble” from the alarm.

If there was an alarm and the

red ARMED/MEMORY light did

not flash, the alarm was a 24 hour

zone (see your Alarm Plan). The

cause of the alarm will have to be

removed before you can clear

the alarm signal.

a