Using your xp-400 security system $50(' 5($' 6 9 =21( =21( =21( =21( napco oi220a page 1 tuesday, september 16, 1997 08:30 www.Ealarm.Com.My.
4 1 bell / battery test test your bell or siren by pressing followed by . This will cause the bell, or siren to sound for 2 seconds and also initiate a test of the battery . 2 central station communication test (this test should only be performed on weekends or at a time designated by your alarm com...
$50(' 5($' 6 9 =21( =21( =21( =21( keypad controls and indicators ready light will light when all zones are secure and system is ready to be armed. Zone lights (1 through 4)will light to indicate that the corresponding zone is open, and will flash to indicate a zone in alarm. Armed light will light ...
Arming your system when leaving 1 before arming your system, make sure the green ready light is on. This indicates that all of your prot- ective zones are secure. If any zones are open, the corresponding zone light will be on. Secure these zones before proceeding. If any zones cannot be secured, see...
Protecting yourself while at home 1 before arming your system, make sure the green ready light is on. This indicates that all of your protective zones are secure. If any zones are open, the corresponding zone light will be on. Secure those zones before proceeding. 2 enter your user code. The green r...
Emergency buttons the two sets of emergency buttons, if programmed, are always active whether the system is armed or disarmed. Discuss these buttons with your installer. The emergency signal will only be activated when the two respective buttons are pressed at the same time. Auxiliary alarm: simulta...
Disarming your system when returning 1 enter your premises through the entry/exit door. The keypad will sound a steady tone to remind you to disarm the system before your entry delay time expires. 2 enter your user code. The red armed light will go out, indicating that the system has been disarmed. ...
Special functions by pressing followed by the appropriate key, (do not press simultaneously) these special functions and features can be enabled: easy arm (when system is disarmed) the easy arm feature allows the system to be armed by pressing ! Followed by . This will allow the easy arming of the s...
Your installer has assigned a user 1 code which may be used to not only arm and disarm the system, but also to enter the user program mode, where you can program and/or reprogram up to 4 user codes. The following explains how you will use this code to program or erase additional user codes. Entering...
The xp400 is constantly monitoring its own components, as well as all critical services, such as ac power and the telephone line, to insure that it is always ready to provide the protection for which it was designed. When a system trouble does occur, it will caution you by lighting the yellow 9 9 sy...
13 9 system troubles keypad beeps or 9 9 system flashes zone light on system trouble condition action 2 beeps 1 bell / siren trouble there is a problem with the bell or siren. Call installing com- pany for service. 2 beeps 3 wireless receiver trouble a problem has been detected with the wireless rec...
