1 w415-0808 / a / 11.09.10 installer: leave this manual with the appliance. Consumer: retain this manual for future reference. Installation and operating instructions 1.22 wolf steel ltd., 24 napoleon rd., barrie, on, l4m 4y8 canada / 103 miller drive, crittenden, kentucky, usa, 41030 phone (705)721...
2 w415-0808 / a / 11.09.10 a. Attach the burner assembly to the fi rebox base with the screws supplied, making sure the pilot assembly is closest to the valve access opening. 1.0 general information 2.0 installation note: changes, other than editorial, are denoted by a line in the margin. Table of c...
3 w415-0808 / a / 11.09.10 2.3 bulkheads note: bulkhead covers need to be removed. A. Connect the gas fl ex lines and the pilot line to the gas bulkheads located under the valve access opening. Be sure to match up the gas manifold marked with an orange dot with the center bulkhead, also marked with ...
4 w415-0808 / a / 11.09.10 install in the following order: a. Side porcelain panels or brick panels must be installed prior to porcelain base cover plates. For side porcelain panel installation see “prp81 porcelain reflective radiant panel” leafl et and for brick panel installation see “gd844kt deco...
5 w415-0808 / a / 11.09.10 2.7 rock installation ! Warning real rocks must not be used in this appliance. Heat will cause them to explode. A. Position the two rock clusters in front of the center burner tube, ensuring the clusters are sitting fl at on the burner and making sure not to cover burner p...
6 w415-0808 / a / 11.09.10 it’s important to periodically perform a visual check of the pilot and burner fl ames. Compare them to the illustra- tions provided. If any fl ames appear abnormal call a service person. 3/8” - 1/2” pilot burner flame must envelop upper 3/8” to 1/2” of flame sensor flame s...
7 w415-0808 / a / 11.09.10 4.0 replacements components ref no. Part no. Description 1 w280-0071 night light lens frame 2 w290-0080 night light gasket 3 w300-0086 ceramic blue night light lens 4 w350-0460 rock burner housing 5 w100-0113 double tube burner 6* w175-0227 connector, 3/8” stainless steel ...
8 w415-0808 / a / 11.09.10 44.1 5.0 notes.
1 w415-0713 / a / 11.09.10 installer: leave this manual with the appliance. Consumer: retain this manual for future reference. Installation and operating instructions 1.22 wolf steel ltd., 24 napoleon rd., barrie, on, l4m 4y8 canada / 103 miller drive, crittenden, kentucky, usa, 41030 phone (705)721...
2 w415-0713 / a / 11.09.10 a. Once either door is removed (see installation instructions), remove the valve access panel and the 4 retaining brackets located at the top of the fi rebox. A. Attach the burner assembly to the fi rebox base with the screws supplied, making sure the pilot assembly is clo...
3 w415-0713 / a / 11.09.10 note: bulkhead covers need to be removed. A. Connect the gas fl ex lines and the pilot line to the gas bulkheads located under the valve access opening. Be sure to match up the gas manifold marked with a green dot with the center bulkhead, also marked with a green dot. Car...
4 w415-0713 / a / 11.09.10 gasket lens frame coloured side up your hd81 comes equipped with 2 “night lights™”. The lights have been pre-wired and are controlled from the remote control. Included with the burner assembly are the frames, lenses and gaskets that need to be installed as shown. The fireb...
5 w415-0713 / a / 11.09.10 notch 2.6 log placement a. Place the left middle log #1 onto the locating stud on the middle log support. Make sure the hollow on the underside of the log is over the bend tab. B. Slide log #2 from right to left on the middle log support creating a tight fi t between logs ...
6 w415-0713 / a / 11.09.10 g. Slide the fl at portion of log #7 under the second grate post. Note: logs 3, 4, 5, 6 and 7 are included twice. Install these logs on the opposite side. Logs 8 and 9 are only included once, to give a different appearance to each side. Install logs 8 and 9 on the side tha...
7 w415-0713 / a / 11.09.10 air shutter openings both burners lp 7/16” ng 3/16” 2.9 vermiculite 33.1 sprinkle vermiculite around the charcoal embers. Note: vermiculite is not to be placed on the burner. 2.10 glowing embers tear the embers into pieces and place along the front row of ports covering al...
8 w415-0713 / a / 11.09.10 installation and repairs must be performed by a qualifi ed installer, service agency or the supplier. 4.0 replacements components ref no. Part no. Description 1 w280-0071 night light lens frame 2 w290-0080 night light gasket 3 w300-0067 ceramic orange night light lens 4 w1...
9 w415-0713 / a / 11.09.10 7 1 2 3 21 20 4 2 12 11 13 14 15 16 17 18 19 4 4 10 9 8 27 26 28.
10 w415-0713 / a / 11.09.10 44.1 5.0 notes.
11 w415-0713 / a / 11.09.10 44.1.
12 w415-0713 / a / 11.09.10 44.1.
1 w415-0712 / a / 11.09.10 installer: leave this manual with the appliance. Consumer: retain this manual for future reference. Installation and operating instructions 1.22 wolf steel ltd., 24 napoleon rd., barrie, on, l4m 4y8 canada / 103 miller drive, crittenden, kentucky, usa, 41030 phone (705)721...
2 w415-0712 / a / 11.09.10 a. Attach the burner assembly to the fi rebox base with the screws supplied, making sure the pilot assembly is closest to the valve access opening. 1.0 general information 2.0 installation note: changes, other than editorial, are denoted by a line in the margin. Table of c...
3 w415-0712 / a / 11.09.10 2.3 bulkheads note: bulkhead covers need to be removed. A. Connect the gas fl ex lines and the pilot line to the gas bulkheads located under the valve access opening. Be sure to match up the gas manifold marked with a green dot with the center bulkhead, also marked with a ...
4 w415-0712 / a / 11.09.10 2.4 night light™ installation gasket lens frame coloured side up night light 1 2 1 the porcelain base is shipped separate from the appliance and is included with the burner assembly. Install in the following order: note: burner assembly must be installed fi rst. A. Side po...
5 w415-0712 / a / 11.09.10 c. Align the 4 tabs on the porcelain base 2 down to line up with the holes in the burner tray. Secure using the screws provided. Bend tabs pilot assembly 2 74.1 evenly spread the glass media onto the media tray, covering the burner tube and following the natural shape of t...
6 w415-0712 / a / 11.09.10 it’s important to periodically perform a visual check of the pilot and burner fl ames. Compare them to the illustra- tions provided. If any fl ames appear abnormal call a service person. 3/8” - 1/2” pilot burner flame must envelop upper 3/8” to 1/2” of flame sensor flame s...
7 w415-0712 / a / 11.09.10 4.0 replacements components ref no. Part no. Description 1 w280-0071 night light lens frame 2 w290-0080 night light gasket 3 w300-0086 ceramic blue night light lens 4 w035-0272 porcelain glass burner base 5 w100-0106 double tube burner 6* w175-0227 connector, 3/8” stainles...
8 w415-0712 / a / 11.09.10 44.1 5.0 notes.
