Napoleon PTH10PSS Manual,instructions & Parts List

Manual is about: Tabletop Patio Heater

Summary of PTH10PSS

  • Page 1

    Tabletop patio heater tabletop patio heater manual,instructions & parts list (for outdoor use only) for your safety if you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. If odor continues ,immediately call gas supplier. For your safety do not store or use gasoline or o...

  • Page 2

    2 tools and parts needed for assembly tools and parts needed for assembly tools needed: adjustable opening wrench, 8 long philips head screwdriver leak detection solution ( instructions how to make solution are included in step 5 ) for outdoor use only. Cylinders to be used must be constructed and m...

  • Page 3: Parts List

    1 1 2 2 3 3 4 4 5 5 6 6 3 parts list parts list 7 7 7 7 8 8 8 8 3 hex nut 6 washer 1 hose assy (not supplied) 10 10 11 11 12 12 13 13 14 14 1 stretch line (not supplied) the fasteners used comply with ansi/bl.1 save these instructions! Retain in a safe place for future reference. 9 9 7 8-32unc screw...

  • Page 4: Precautions

    4 precautions precautions do not use the heater in an explosive atmosphere. Keep the heater away from areas where gasoline or other flammable liquids or vapors are stored. Prior to use, check for damaged parts such as hoses, regulators, pilot or burner. Never replace or substitute the regulator with...

  • Page 5: Precautions

    5 precautions precautions note: please read the following safety rules warning: the hose assembly should be properly located out of pathways where people may trip over it. The hose must be protected from contract with hot or sharp surfaces both during use and while in storage. If excessive abrasion ...

  • Page 6: Assembly

    2 2 1 1 6 assembly assembly step 1 ---- 8-32 unc l=6 (7 pcs) attach h to base using eater assembly warning : to be installed only by an authorised person attach heater assembly to base heater assembly 10 10 3 3 2 2 step 2 ---- attach the burner column to the hounsing into the spring piece (3 pcs) of...

  • Page 7: Assembly

    7 7 step 4 ---- 8 8 attach reflector dome to emitter screen of the eater assembly using 1/4-20 unc washers (6 pcs) and 1/4-20 unc nuts (3 pcs). Then attach dome cap and decorative dome cap nut to reflector dome. H attach reflector dome and dome cap and decorative dome cap nut to emitter screen 5 5 1...

  • Page 8: Assembly

    88 assembly assembly step 5 ---- attach emitter screen shield to burner column . Warning : to be installed only by an authorised person attach emitter screen shield to burner column step 6 ---- attach regulator to cylinder. Attach gas hose to regulator. Connect gas hose, regulator and cylinder of th...

  • Page 9: Assembly

    9 assembly assembly warning : to be installed only by an authorised person step 7 ---- check for leak your patio heater has been checked at all factory connections for leaks, to check the connection of the gas hose/regulator/cylinder. 1) make leak solution by mixing 1part liquid dish soap and 3 part...

  • Page 10: Operation

    10 operation operation if you experience any ignition problem, turn off the heater and gas supply, and consult "troubleshooting" on page 14. Lighting instruction 1. Turn control knob clockwise to "off" position. 2. Open base assembly door. 3. Turn gas supply "on" by connecting propane cylinder to re...

  • Page 11: Operation

    11 operation operation caution : avoid inhaling fumes emitted from the heater's first use. Smoke and odor from the burning of oils used in manufacturing will appear. Both smoke and odor will dissipate after approximately 30 minutes. The heater should not produce thick black smoke. " " o w note: when...

  • Page 12: Locating Header For Use

    Locating header for use locating header for use 12 figure 1 12" this heater is primarily used for the heating of outdoor patios, decks, spas, pool and open working areas. Always make sure that adequate fresh air ventilation is provided. Follow the spacing tolerances shown in figure 1. The minimum cl...

  • Page 13: Maintenance/storage

    Maintenance/storage maintenance/storage 13 maintenance : to enjoy years of outstanding performance from your heater make sure you perform the following maintenance activities on a regular basis: keep exterior surfaces clean. Use warm soapy water for cleaning. Never use flammable of corrosive cleanin...

  • Page 14: Troubleshooting

    Troubleshooting troubleshooting 14 problem probable cause solution pilot will not light gas valve may be off turn the gas valve on orifice blocked clean or replace orifice air in supply system purge air from lines loose connection check all fittings pilot will not stay on debris around pilot clean d...