Napoleon PTH55PSS-1 User Installation And Operation Manual

Manual is about: Napoleon Terrace And Patio Heater

Summary of PTH55PSS-1

  • Page 1

    Terrace and patio heater user installation and operation guide index general and specifications ……………….1,2 security and caution …………………….. 3 tools and accessories required ………… 5 assembly instructions …………………… 5 - 7 operation (lighting instruction) ………… 9 parts available to order ………………... 10 warran...

  • Page 2

    1 read safety requirements before operation 1. The installation must conform with local codes or in the absence of local codes, with either the national fuel gad code, ansi z223.1, or csa b149.1, propane installation code. 2. This outdoor gas appliance is not intended to be installed in or on recrea...

  • Page 3: Warning:

    2 warning: 1. Children and adults should be alerted to the hazards of high surface temperature and should stay away to avoid burns or clothing ignitions. 2. Young children should be carefully supervised when they are in the area of the heater. 3. Clothing or other flammable materials should not be h...

  • Page 4

    3 the manufacturer. 6. The cylinder must be provided with a shutoff valve terminating in an lp-gas supply cylinder valve outlet specified, as applicable, for connection no. 510 in the standard for compressed gas cylinder valve outlet and inlet connections, ansi/cga-v-1. 7. The cylinder supply system...

  • Page 5

    4 caution ● faulty installation, modifications, repairs or maintenance to the appliance may be the cause of injury or damage to property. ● carefully read this user guide before assembling and setting up the heater. ● keep this guide for future reference. ● do not operate the heater in an explosive ...

  • Page 6

    5 tools and equipment required 10 and 13mm wrench, philips screwdriver, medium blade leak test solution: mix 50/50 water and soap 1 propane cylinder (not supplied), with qcc 1 valve  attention: please start to assemble wheel set first before assembling complete unit. Assembly instruction for wheel ...

  • Page 7

    6 b c fasten post to the vertical supports slide cylinder cover on post. With 6 bolts m6 x 35 and 6 nuts m6. Before assembling the burner head on post, please fix the 3 supported brackets onto burner head for assembling reflector d slide hose through bottom of post and connect to burner head. Then f...

  • Page 8

    7 e assemble the reflector pieces to the middle piece using the small washers and the acorn nuts. F place a steel washer over each bolt on the burner top (figure 8) lay reflector over the burner top bolts add another steel washer to each bolt. G install a full gas cylinder on the base. Connect the g...

  • Page 9

    8 if you detect bubbles, there is a leak. Close cylinder valve completely. Retighten the leaking connection and repeat leak test process. If the leak cannot repaired permanently, close cylinder valve completely and contact the customer service department at 1-866-539-2039 or a qualified gas technici...

  • Page 10

    9 operation to light: 1. From ‘off’ position, depress knob, turn 90° counter-clockwise and hold. 2. Press the igniter until flame is established. 3. Release the knob and check that the flame stays lit. 4. If the flame goes out, wait 5 minutes then repeat steps 1 & 2 above. 5. For maximum temperature...

  • Page 11

    10 parts available to order.

  • Page 12: Limited Product Warranty

    11 limited product warranty this product has a one year limited warranty, which covers workmanship and material quality. Napoleon appliance corporation warrants to the original purchaser only, that when this product is subject to normal use. It is free from defects in workmanship and materials for a...