Napoleon Room Air Conditioner User Manual - page 26

11

ELECTRICAL WORK

Warning

Be sure to comply with local codes while 

running the wire from the indoor unit to

the outdoor unit.

Every wire must be connected firmly.

No wire should be allowed to touch

refrigerant tubing, the compressor 

or any moving parts.

Loose wiring may cause the terminal to

overheat or result in unit malfunction. 

A fire hazard may also exit. Therefore,

be sure all wiring is tightly connected.

Disconnecting means must be provided 

and shall be located within sight from and 

readily accessible from the air conditioner.

Connecting cable with conduit shall go 

 through the hole of the conduit panel.

Note : To prevent wires loosening or leaving

 the Cord Clamp, please select proper cord

 diameter to fill the holes on the cord clamp.

Power supply 

cord

Power supply 

1

 208-230V~60Hz

Special branch circuit breaker

(Fuse/Breaker capacity:20A)

Terminal block of outdoor unit

To indoor unit

To indoor unit

To indoor unit

To power supply

To power supply

To power supply

Fig.23b

L1   L2    S    L 1   L2

1(L) 2(N)  S     L      N

L1   L2    S    L 1   L2

(1)

(2)

(3)