1. DL manuals
  2. Napoleon
  3. Patio Heater
  4. Tabletop Patio Heater
  5. Owner's Manual

Napoleon Tabletop Patio Heater Owner's Manual

Summary of Tabletop Patio Heater

  • Page 1

    Tabletop patio heater owner’s manual standard: ansi z83.26-2007 / csa 2.37-2007 ansi z83.26a-2008 / csa 2.37a-2008 gas-fired outdoor infrared patio heaters. Questions, problems, missing / replacement parts? Before returning to your retailer, call our customer service department at 1-866-814-0585, 8 ...

  • Page 2: Danger

    2 this appliance can produce carbon monoxide which has no odor. Using it in an enclosed space can kill you. Never use this appliance in an enclosed space such as a camper, tent or home. Danger carbon monoxide hazard warning: improper installation, adjustment, alteration, services or maintenance can ...

  • Page 3: Precautions

    3 precautions the installation must conform with local codes or, in the absence of local codes, with the national fuel gas code, ansi z223.1/nfpa 54, nfpa58 natural gas and propane installation code, csa b149.1, or propane storage and handling code, b149.2 the heater, when installed, must be electri...

  • Page 4: Precautions

    4 precautions within a partial enclosure which includes an overhead cover and three side walls, as long as 30 percent or more of the horizontal periphery of the enclosure is permanently open. This appliance requires 16.4oz (1lb) lp_gas supply cylinder. The lp-gas supply cylinder to be used must be: ...

  • Page 5: 35(&$87,216

    5 35(&$87,216 35(&$87,216 35(&$87,216 35(&$87,216 warnings and cautions this heater is designed to operate with a standard 1 ib propane cylinder with approved cylinder connection. Note: please read the following safety rules: tools needed: (not included) adjustable open end wrench philips screwdrive...

  • Page 6: Parts List

    6 parts list please check the contents of the packaging as to whether anything is missing! The fasteners used comply with ansi/bl.1 1 base 1 housing 1 burner column 2 emitter screen shield 1 emitter screen 1 reflector dome 1 dome cap 1 decorative dome cap nut 1 2 3 4 5 6 7 8 9 10 11 12 13 3 7 m4 x 8...

  • Page 7: Assembly

    7 step 1 step 2 assembly warning : only an authorized gas technician should install this product. Step 2 insert the three clamps of the burner column (3) into the three spring pieces of the housing (2) per the picture and screw over. Make sure the clamp and the spring piece fit together. Step 1 atta...

  • Page 8: Assembly

    Step 4 assembly 8 step 3 attach emitter screen (5) to burner column (3) using three m4 x 8 bolts (9) note: the ignition hole on emitter screen must line to the control knob. Step 4 attach reflector dome (6) to emitter screen (5) using six 6mm washers (12) and three m6 nuts (11). Then attach dome cap...

  • Page 9: Assembly

    Assembly 9 step 5 step 6 step 5 attach emitter screen shield (4) to burner column (3) using four m4 x 8 bolts (9). Step 6 open the access door. Open up the gas bottle cover. Attach it to the regulator. Aim at the screw thread. Turn counter clockwise and tighten. 4 4 4 4 3 3 9 hardware used 9 m4 x 8 ...

  • Page 10: Safety Check

    10 safety check check for leak your patio heater has been checked at all factory connections for leakage. To check the connections at the tube/regulator/cylinder. 1) make leakage solution by mixing 1 part liquid dish soap and 3 parts water. 2) spoon several drops (or use squirt bottle) of the soluti...

  • Page 11: Operation

    11 operation before turning gas supply on warning: do not attempt to operate heater until you have read and understand all precaution . Failure to do so can result in serious personal injury, death, or property damage. Before lighting heater should be thoroughly inspected before each use, and by a q...

  • Page 12: Operation

    12 operation flame characteristic the flame pattern at the emitter screen should be visually checked whenever heater is operated. Normally the burner flame is blue, but little yellow flame is acceptable. If flames extend beyond surface of the emitter grid , or the phenomena of flame lift or light ba...

  • Page 13: Operation

    13 operation note: the burner may be noisy when initially turned on. To eliminate excessive noise from the burner, turn the control knob to the "low" position. Then, turn the knob to the level of heater desired. When heater is on: emitter screen will become bright red due to intense heat. The color ...

  • Page 14: Locating Header For Use

    14 locating header for use caution: when certain materials or items are left, above, beside or under this heater while in use, they will be subject to radiant heat and could be seriously damaged. This heater is primarily used for the heating of outdoor patios, decks, spas, pools and open working are...

  • Page 15: Maintenance/storage

    15 maintenance/storage do not touch or move heater for at least 45 minutes after use. Allow all burner elements to cool before touching. For your safety ; warning: note: in a salt-air environment (such as near an ocean). Corrosion occurs more quickly than normal. Frequently check for corroded areas ...

  • Page 16: Maintenance/storage

    16 maintenance/storage note: wait until heater is cool before covering. Turn the control knob to "off" position. Turn clockwise to disconnect cylinder from regulator. Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and debri...

  • Page 17: Troubleshooting

    17 problem probable cause solution pilot will not light gas valve may be off turn the gas valve on tank fuel empty refill lp gas tank air in supply system purge air from lines loose connection loose connection check all fittings pilot will not stay on debris around pilot clean dirty area tighten con...

  • Page 18: One-Year Limited Warranty

    18 one-year limited warranty the appliance has been manufactured under the highest standards of quality and workmanship. We warrant to the original consumer purchaser that all aspects of this product will be free of defects in material and workmanship for one (1) year from the date of purchase. A re...

  • Page 19

    19 srpt03-xxxx color material & base venthole shape reflector reflector 1. 1pc reflector 2. 2pcs reflector 3. 3pcs reflector venthole shape 1. Round 2. Rhombic 3. Rectangle material & base 1. Steel w/ bigger base 2. S/s w/ bigger base 3. Steel w/ smaller base 4. S/s w/ smaller base 8. Cast aluminium...